Lot Size Clause Samples

Lot Size. In an R1 Zone the minimum lot size shall be as follows: (A) The minimum lot area shall be seven thousand fifty (7,050) square feet. (B) The minimum lot width at the front of the building line shall be seventy five feet (75’). (C) The minimum lot depth shall be ninety four feet (94’). (D) The minimum lot area for a two-family dwelling shall be seven thousand fifty (7,050) square feet. The minimum lot area for any multi-family dwelling allowed as a conditional use shall be related to the number of bedrooms in each dwelling unit as prescribed in the following table: Square Feet of Lot Area to be Added for Each Dwelling Unit Over Two

Lot Size. In an R2 Zone, provisions of Section 8.2.4 of this Title, relative to coverage, apply. 288 TITLE VIII ZONING

Lot Size. Each batch, mixed in a single container, shall not be less than 30 gallons nor more than 300 gallons. The State reserves the rights to request a batch run of less than thirty (30) gallons for each item.

Lot Size. Always use fixed lot for copied orders – allows to set any lot size. In this case Source’s lot size will be ignored and the lot size for each order on Receiver side will be set according to entered value. • Use risk management based on Stop Loss - allows you to manage risk for some specific orders. Lot will be calculated due to settled risk percentage.

Lot Size. The minimum size of a traditional single family residential lot within the Property shall be 3,300 square feet in any exclusively single- family master-planned subdivision. The Developer may construct non-traditional homes (such as town homes, condominiums, cluster homes, etc.) on lot sizes generally acceptable for that product in the Houston region, or for other high-density mixed-use developments in major metropolitan areas, provided, however, development of residential lots within the Property shall be in accordance with the General Plan and the requirements of this Agreement.

Lot Size. The Developer currently proposes land uses as shown on the Land Plan attached as Exhibit E. For purposes of this Agreement, the Developer can develop the Tract to any residential lot size without limitation subject to the terms of and lot sizes set out in this Agreement. The Developer agrees that it will develop traditional single familysingle-family lots in at least three different lot sizes. The Developer will also develop lots for Non-Traditional Homes to provide an additional mix of product types within the community. The Developer agrees that the mix of housing product at ultimate build out will meet the following : Lot Size/Product Type Minimum Percentage of Lots 50-54 feet 10%, provided, however, not more than 50% of the number of lots will be within this lot size band 55-59 feet 10% 60+ feet (includes 60s,65s, 70s, 75s, 80s ) 10%

Lot Size. Standard lots: Single burial lot: 4 ft. x 10 ft. Double burial lot: 8 ft. x 10 ft. East Circle Urn Plots: 2 ft. x 2 ft.

Lot Size. A range of lot sizes shall be provided in order to create variety and offer opportunity for different income households. The minimum lot sizes shall be as follows; provided that, minor adjustments to lot sizes based upon site engineering will be considered as minor amendments so long as the minimum size is met: ▇▇▇ ▇▇▇▇▇ ▇▇▇ ▇▇▇▇▇ ▇▇▇▇ ▇▇ ▇▇▇▇▇ ▇ Lots in Phase 2 Lots in Phase 3 Total Lot Types 40’ 115’ 79 37 111 227 50’ 115’ 63 50 70 183 60’ 115’ 79 54 86 219 Total Lots Per Phase 221 141 267 629

Lot Size. The minimum lot size should be a minimum of 4 acres with a minimum lot width of 100 feet. The building should be located towards the front of the lot with visual access from the street. No portion of the lot shall be used to access adjoining property or properties.