Managed Switch Clause Samples

Managed Switch. Managed Switch Services involve ▇▇▇▇▇▇ managing your switch on your behalf. You do not have access to the switch. Managed Switch Services include: a) real-time SNMP monitoring; b) daily back-ups of the switch configuration for rapid restoration of the hardware; c) real-time logging of all switch devices to a ▇▇▇▇▇▇ log server; d) reporting of switch interface traffic in 5 minute intervals and graphing of results in your portal; e) reporting of interface errors in 60 minute intervals and graphing of results in your portal; f) reporting of CPU and memory usage in 5 minute intervals and graphing in your portal; g) performance of switch configuration changes as requested by you (2 configuration changes are included per month, after which there is a one-time charge per change, which is currently $50.00, but is subject to change without notification); h) OS patching and hotfix; i) monitoring of all up-links for up/down status and incident management as required; and j) monitoring of bandwidth thresholds and incident management as required.
View Source

Related to Managed Switch

  • Managed Services HP will provide the services as described in a Statement of Work (“SOW”) attached to this Agreement or incorporating it by reference. Each party will appoint a single point of contact as set forth in the SOW who will serve as their primary representative, have overall responsibility for managing performance, and meet with the other party’s representative to review progress. Change requests are governed by the change management procedures as set forth in the SOW.

  • Tandem Switching 4.5.1 The Tandem Switching capability Network Element is defined as: (i) trunk-connect facilities, which include, but are not limited to, the connection between trunk termination at a cross-connect panel and switch trunk card; (ii) the basic switch trunk function of connecting trunks to trunks; and (iii) the functions that are centralized in the Tandem Switches (as distinguished from separate end office switches), including but not limited to call recording, the routing of calls to operator services and signaling conversion features. 4.5.2 Where <<customer_short_name>> utilizes portions of the BellSouth network in originating or terminating traffic, the Tandem Switching rates are applied in call scenarios where the Tandem Switching Network Element has been utilized. Because switch recordings cannot accurately indicate on a per call basis when the Tandem Switching Network Element has been utilized for an interoffice call originating from a UNE port and terminating to a BellSouth, Independent Company or Facility-Based CLEC office, BellSouth has developed, based upon call studies, a melded rate that takes into account the average percentage of calls that utilize Tandem Switching in these scenarios. BellSouth shall apply the melded Tandem Switching rate for every call in these scenarios. BellSouth shall utilize the melded Tandem Switching Rate until BellSouth has the capability to measure actual Tandem Switch usage in each call scenario specifically mentioned above, at which point the rate for the actual Tandem Switch usage shall apply. The UNE Local Call Flows set forth on BellSouth's website, as amended from time to time and incorporated herein by this reference, illustrate when the full or melded Tandem Switching rates apply for specific scenarios.

  • Local Switching 4.1 BellSouth shall provide non-discriminatory access to local circuit switching capability and local tandem switching capability on an unbundled basis, except as set forth in the Sections below to Choice Telephone Company for the provision of a telecommunications service. BellSouth shall provide non-discriminatory access to packet switching capability on an unbundled basis to Choice Telephone Company for the provision of a telecommunications service only in the limited circumstance described below in Section 4.5.

  • NON-NETWORK PROVIDER is a provider that has not entered into a contract with us or any other Blue Cross and Blue Shield plan. For pediatric dental care services, non-network provider is a dentist that has not entered into a contract with us or does not participate in the Dental Coast to Coast Network. For pediatric vision hardware services, a non-network provider is a provider that has not entered into a contract with EyeMed, our vision care service manager.

  • Network Access During its performance of this Contract, Contractor may be granted access to Purchaser’s computer and telecommunication networks (“Networks”). As a condition of Network use, Contractor shall: (a) use the Networks in compliance with all applicable laws, rules, and regulations; (b) use software, protocols, and procedures as directed by Purchaser to access and use the Networks; (c) only access Network locations made available to Contractor by Purchaser; (d) not interfere with or disrupt other users of the Networks;