Meter Sample Clauses
The Meter clause defines how the measurement of utility usage, such as electricity, water, or gas, will be conducted and recorded at a property. Typically, it specifies whether meters are individual or shared, who is responsible for reading the meters, and how usage data will be reported and billed. This clause ensures accurate allocation of utility costs and prevents disputes by clearly outlining the process for tracking and charging for consumption.
POPULAR SAMPLE Copied 1 times
Meter. System Owner shall install the Meter at the Delivery Point to measure the amount of Output delivered by System Owner to Host Customer. System Owner shall own, operate and maintain the Meter during the Term at its own expense.
Meter. (S) and METER READINGS
a. Equipment required to meter service hereunder shall be installed, owned or leased, operated and maintained by the University or Prairieland. Prairieland shall not be responsible for the installation, operation, or maintenance of any installed equipment on the University side of the Point(s) of Delivery. Prairieland will coordinate with the University’s utility operations to install or remove Prairieland’s meters which are put into service on the University’s system.
b. The University shall notify Prairieland of any issues that impact the accuracy of the meter function.
c. Prairieland and the University shall work cooperatively to provide for the reading of meters and the sharing of meter data for billing purposes.
Meter. Seller shall, at its sole cost and expense, install, operate, maintain, repair, replace, and test the Meter at the Delivery Point to measure the amount of Output delivered by Seller to Purchaser and actually consumed by Purchaser. Seller shall operate and maintain the Meter in accordance with Prudent Industry Practices.
Meter. The System’s electricity output during the Term shall be measured by Seller’s meter, which shall be a revenue grade meter that meets ANSI-C12.20 standards for accuracy (the “Meter”). Purchaser shall have access to the metered energy output data via the [ ] monitoring system installed and maintained by Seller as part of the System.
Meter testing You may ask for information about your meter readings and meter registration for each or any nominated premises and QEnergy will endeavour to provide this information as soon as practical. QEnergy may pass on to you its costs of collecting and releasing information regarding half hourly meter registration. If you are not satisfied with any ▇▇▇▇ review, you can also ask for your meter to be tested. Where the meter is found to be faulty or inaccurate, it will be repaired and there will be no charge for the test. If there is no fault with the meter, you agree QEnergy may debit from your nominated bank account the whole of any payment for the test as well as the outstanding balance of the ▇▇▇▇.
Meter. Provider shall provide and maintain a standard revenue grade meter and electronic data acquisition system at the Delivery Point (“Generation Meter”) to measure the actual amount of Output supplied to District by the Solar Facility on a continuous basis. Meters shall be installed and maintained at Provider’s sole expense and shall be located on the Distribution Utility side of all major electrical losses and within close proximity to the Delivery Point.
Meter. (a) You do not own the Meter at your Premises. The Meter may be owned by us, the Distributor, or the Metering Service Provider.
(b) You must allow us or our representative safe, convenient, and unhindered access to your Premises for the purpose of reading your Meter and to maintain, inspect, test, repair, install, exchange, replace, alter or remove your Meter (subject to applicable Energy Laws). We or our representative will carry or wear official identification and show that identification to you on request.
(c) In addition, it is your responsibility to:
i. keep your Meter clear of hazards and interference;
ii. not to tamper, or not to permit tampering, with any Meter or associated equipment at your Premises;
iii. keep your Meter and any ancillary equipment and connections in good condition and repair; and
iv. comply with any relevant requirements of the Distributor or the Metering Service Provider (if any).
Meter. A fire hydrant meter that measures the quantity of water supplied through the register and additional backflow prevention assembly.
Meter. Client agrees to install software for the purpose of collecting meter, consumable and break/fix information. If Client does not install software to provide MBS with meter readings within five (5) days of an MBS request, MBS may estimate the current meter reading. MBS may communicate its request by phone, fax, email, other mail service, or in person.
i. MBS will Install. MBS will install appropriate software to collect this information for Client upon request.
Meter testing You may ask for information about your meter readings and meter registration for each or any nominated premises and QEnergy will endeavour to provide this information as soon as practical. QEnergy may pass on to you its costs of collecting and releasing information regarding half hourly meter registration. If you are not satisfied with any ▇▇▇▇ review, you can also ask for your meter to be tested. Where the meter is found to be faulty or inaccurate, it will be repaired and there will be no charge for the test. If there is no fault with the meter, you agree to pay QEnergy (or if you pay by direct debit, QEnergy may debit your nominated bank account) the whole of any payment for the test as well as the outstanding balance of the ▇▇▇▇.