Method 3 Clause Samples
Method 3. Financial offer and quality
(a) Score each tender in respect of the financial offer made and the quality offered in accordance with the provisions of F.3.11.7 and F.3.11.9, rejecting all tender offers that fail to score the minimum number of points for quality stated in the tender data, if any.
(b) Calculate the total number of tender evaluation points (TEV) in accordance with the following formula: TEV = NFO + NQ where: NFO is the number of tender evaluation points awarded for the financial offer made in accordance with F.3.11.7; NQ is the number of tender evaluation points awarded for quality offered in accordance with F.3.11.9.
(c) Rank tender offers from the highest number of tender evaluation points to the lowest.
(d) Recommend tenderer with the highest number of tender evaluation points for the award of the contract, unless there are compelling and justifiable reasons not to do so.
(e) Rescore and re-rank all tenderers should there be compelling and justifiable reasons not to recommend the tenderer with the highest number of tender evaluation points and recommend the tenderer with the highest number of tender evaluation points, unless there are compelling and justifiable reasons not to do so and the process set out in this sub clause is repeated.
Method 3. The amount determined by any reasonable method of allocating income or loss to the Participant’s Excess Aggregate Contributions for the Plan Year and for the gap period, provided the method used is the same method used for allocating income or losses to Participants’ Accounts. This Plan will not fail to use a reasonable method for computing the income allocable to Excess Aggregate Contributions merely because the income allocable to such Excess Aggregate Contributions is determined on a date that is no more than 7 days before the distribution.
Method 3. Financial offer and quality
Method 3. Financial offer and quality In the case of a financial offer and quality:
a) Score each tender in respect of the financial offer made and the quality offered in accordance with the provisions of F.3.11.7 and F.3.11.9, rejecting all tender offers that fail to score the minimum number of points for quality stated in the tender data, if any.
b) Calculate the total number of tender evaluation points (TEV) in accordance with the following formula:
Method 3. Audit your system
Method 3. In case of a financial offer and quality:
a) Score quality, rejecting all tender offers that fail to score the minimum number of points for quality stated in the tender data, if any.
b) Score tender evaluation points for each financial offer.
c) Calculate the total tender evaluation points.
d) Rank tender offers from the highest number of tender evaluation points to the lowest.
e) Recommend tenderer with the highest number of tender evaluation points for the award of the contract, unless there are compelling and justifiable reasons not to do so.
Method 3. The surface shall be covered with moist earth not less than 4 hours nor more than 24 hours after the concrete is placed. Earthwork operations that may damage the concrete shall not begin until at least 7 Days after placement of concrete.
Method 3. As an alternative to Method 2, replace the original actuating shaft with a new reinforced shaft according to Figure 1. For rigging and derigging procedures, refer to the flight manual, page E12. After accomplishing repairs according to Method 2, or replacement of the actuating shaft according to Method 3, the aileron deflections must be checked. Plates, welding material, and spare parts as mentioned are available from the manufacturer.
Method 3. The amount determined by any reasonable method of allocating income or loss to the Participant’s Excess Elective Deferrals for the taxable year and for the gap period, provided the method used is the same method used for allocating income or losses to the Participant’s Account (or any sub-account of the Participant’s Account). This Plan will not fail to use a reasonable method for computing the income allocable to excess deferrals merely because the income allocable to such excess deferrals is determined on a date that is no more than 7 days before the distribution.
Method 3. Full payment of the Retainer is required prior to the start of work. If replenish of Retainer is required full payment of the agreed upon amount is required within 5 business days for continuation of the work.