Monitoring Points Clause Samples

POPULAR SAMPLE Copied 1 times
Monitoring Points. In order to monitor settlement and vibration within the Site and the vicinity thereof, the Contractor shall install and maintain appropriate monitoring points including extensometers, vibration monitoring systems, vibration wire strain gauges, piezometers, ground settlement markers and building settlement markers, etc. Some of the monitoring points may be located outside the boundary of the Site. The Contractor is responsible for obtaining the necessary consents, permits and access from the relevant authorities and building owners, and to allow continued maintenance of such points throughout the entire Contract Period. All monitoring points shall be maintained at all times during the contract period.
View Source
Monitoring Points. ▇▇▇▇▇▇▇▇▇▇▇ ▇-▇, ▇-▇, ▇▇-▇, ▇▇-▇, ▇▇-▇▇, ▇-▇, ▇▇-▇▇, MW3-2R, ▇▇-▇, ▇▇-▇, ▇▇-▇, ▇▇-▇, ▇▇▇-▇, UPG-2 MW-4 and MW-4P are in close proximity, therefore only one well needs to be monitored for the parameters listed in Table A. The other well (MW-4P) is intended as a piezometer well and shall be monitored for water elevation only. MW-4 is considered a POC well. ▇▇▇▇▇ ▇▇▇-▇, ▇▇▇-▇, and MW-3 shall be monitored for water elevation only.
View SourceView Similar (5)
Monitoring Points. Leachate-Impacted Groundwater ▇-▇, ▇-▇▇, ▇-▇▇, ▇-▇, P-2A, P3-PZ, ▇-▇, ▇▇-▇-▇▇, ▇-▇, ▇▇-▇, ▇▇-▇▇*, ▇▇▇-▇▇, ▇▇-▇*, ▇▇-▇▇, PZ-3A*, PZ-3B*, PZ-3C All ▇▇▇▇▇ shall be monitoring for water elevation. All ▇▇▇▇▇ shall be monitored for chemical constituents outlined in Table A (Attached) once every 5 Years. ▇▇▇▇▇ denoted with an asterisk (*) shall be monitored for leachate elevations only.
View SourceView Similar (5)
Monitoring Points. 3.5.1. Each transmitter shall be equipped with output monitoring points as follows:- • At the intermediate frequency [if applicable], • On each of the final power amplifiers, • After the amplifier output combiner, • After the band pass output filter • A sample of the local oscillator frequency. 3.5.2. The output monitor points must be calibrated and shall be fed from directional couplers with a directivity of at least 30dB. 3.5.3. The source impedance of such monitoring points shall be 50 ohm unbalanced and the output levels as high as appropriately possible, but not exceeding ten (10) milliwatts (0.707 Volts).
View Source
Monitoring Points. 11.1.1. The equipment shall be provided with monitoring facilities which the manufacturer regards as necessary for the alignment, testing, maintenance and operation of the transmitter or sections thereof. 11.1.2. If any additional software is required to download data or to repair/maintain the equipment locally, it must be included with the Transmitter price at no extra cost to Sentech.
View Source

Related to Monitoring Points

  • Monitoring System In each case in which the Custodian has exercised delegated authority to place Assets with a Foreign Custodian, the Custodian shall establish a system, to re-assess or re-evaluate selected Foreign Custodians, at least annually in accordance with Rule 17f-5(c)(3).

  • Number Resources, Rate Center Areas and Routing Points 13.1 Nothing in this Agreement shall be construed to limit or otherwise adversely affect in any manner either Party’s right to employ or to request and be assigned any Central Office Codes (“NXX”) pursuant to the Central Office Code Assignment Guidelines and any relevant FCC or Commission orders, as may be amended from time to time, or to establish, by Tariff or otherwise, Rate Center Areas and Routing Points corresponding to such NXX codes. 13.2 It shall be the responsibility of each Party to program and update its own switches and network systems pursuant to information provided on ASRs as well as the LERG in order to recognize and route traffic to the other Party’s assigned NXX codes. Except as expressly set forth in this Agreement, neither Party shall impose any fees or charges whatsoever on the other Party for such activities. 13.3 Unless otherwise required by Commission order, the Rate Center Areas will be the same for each Party. During the term of this Agreement, Onvoy shall adopt the Rate Center Area and Rate Center Points that the Commission has approved for Frontier within the LATA and Tandem serving area. Onvoy shall assign whole NPA-NXX codes to each Rate Center Area unless otherwise ordered by the FCC, the Commission or another governmental entity of appropriate jurisdiction, or the LEC industry adopts alternative methods of utilizing NXXs. 13.4 Onvoy will also designate a Routing Point for each assigned NXX code. Onvoy shall designate one location for each Rate Center Area in which the Onvoy has established NXX code(s) as the Routing Point for the NPA-NXXs associated with that Rate Center Area, and such Routing Point shall be within the same LATA as the Rate Center Area but not necessarily within the Rate Center Area itself. Unless specified otherwise, calls to subsequent NXXs of Onvoy will be routed in the same manner as calls to ▇▇▇▇▇’s initial NXXs. 13.5 Notwithstanding anything to the contrary contained herein, nothing in this Agreement is intended, and nothing in this Agreement shall be construed, to in any way constrain Onvoy’s choices regarding the size of the local calling area(s) that Onvoy may establish for its Customers, which local calling areas may be larger than, smaller than, or identical to Frontier’s local calling areas.

  • System Logging The system must maintain an automated audit trail which can 20 identify the user or system process which initiates a request for PHI COUNTY discloses to 21 CONTRACTOR or CONTRACTOR creates, receives, maintains, or transmits on behalf of COUNTY, 22 or which alters such PHI. The audit trail must be date and time stamped, must log both successful and 23 failed accesses, must be read only, and must be restricted to authorized users. If such PHI is stored in a 24 database, database logging functionality must be enabled. Audit trail data must be archived for at least 3 25 years after occurrence.

  • Baseline For purposes of measuring a reduction in net tax revenue, the interim final rule measures actual changes in tax revenue relative to a revenue baseline (baseline). The baseline will be calculated as fiscal year 2019 (FY 2019) tax revenue indexed for inflation in each year of the covered period, with inflation calculated using the Bureau of Economic Analysis’s Implicit Price Deflator.163 FY 2019 was chosen as the starting year for the baseline because it is the last full fiscal year prior to the COVID– 162 See, e.g., Tax Policy Center, How do state earned income tax credits work?, https:// ▇▇▇.▇▇▇▇▇▇▇▇▇▇▇▇▇▇▇.▇▇▇/▇▇▇▇▇▇▇▇-▇▇▇▇/▇▇▇-▇▇- state-earned-income-tax-credits-work/ (last visited May 9, 2021).

  • Configuration Management The Contractor shall maintain a configuration management program, which shall provide for the administrative and functional systems necessary for configuration identification, control, status accounting and reporting, to ensure configuration identity with the UCEU and associated cables produced by the Contractor. The Contractor shall maintain a Contractor approved Configuration Management Plan that complies with ANSI/EIA-649 2011. Notwithstanding ANSI/EIA-649 2011, the Contractor’s configuration management program shall comply with the VLS Configuration Management Plans, TL130-AD-PLN-010-VLS, and shall comply with the following: