Monthly Preventive Maintenance Services Sample Clauses

Monthly Preventive Maintenance Services. 1. (centralised system) – Admin, VC building and underground Control room aircon system  Inspect air intake filters for dirt, blocked and clean or replace if necessary.  Inspect indoor filter conditions (evaporating and condenser section); if necessary clean/wash or replace them. Clean condenser filter on the outside by using compressed air and if there is heavy staining, use a moderate anti-corrosive water-jet.  Check for cracks between filter frames or between the bank of frames and the duct walls to prevent leaking of unfiltered air.  Check the condition of the filter frames and repair/replace if necessarily Condensation water drain  Inspect for any dirt or solids clogging and test it for flow through and clean where necessary.
View Source
Monthly Preventive Maintenance Services. The Vendor shall conduct a total of eleven (11) monthly preventive maintenance services on all units and systems covered under this Contract. The services shall include, at minimum, the following activities: 1. Check for condensate leaks and inspect condition of blower drive belt of the air- handling unit. Check and adjust tension and replace belt if worn. 2. Clean air filters, including return air grills, and replace all disposable air filters and supply grills. 3. Inspect, clean, and lubricate as per Operations & Maintenance (O&M) specifications, (VAV dampers require a special lubricant), tighten all electrical contacts, secure any related duct work to the VAV Dampers control devices, including but not limited to, gauges, variable air volume/dampers, sensors, metering devices, thermostats, temperature and safety controls, and place in normal operating mode. Inspect and change the batteries to all thermostat (remote or wall mount devices) if necessary. 4. Maintain the area around all units free of vegetation, debris and safety hazards (minimum 36 inches 180 degrees). 5. Clean condensate/drain pans, lines and add algicide. 6. Check motors for vibration, noise, and general condition. Note any potential problems. Check and note motor amperage, voltage, power (HP) and speed against manufacturer specifications. 7. Check and note condition of all pumps including condition of the seal, make of seal packing, capacity (GPM), head (feet) and pressure in/out. 8. Inspect and/or replace all rotating equipment including associated components, such as couplings, drives, belts and hold-down bolts, as needed. 9. Lubricate motors. Check motor electrical insulation and wiring insulation between motor and starter on all hermetic compressors (except fractional horsepower motors), primary pumps, and all other large motors included in the equipment, in accordance with the manufacturer’s recommendations. Inspect electrical connections, switches, relays, and conductors for tightness, cleanliness, alignment, condition and proper operation. Apply contact cleaner.
View Source

Related to Monthly Preventive Maintenance Services

  • Maintenance Services Subject to Client’s timely payment of the applicable maintenance fees, Accenture will make available the following maintenance services (“Maintenance Services”):

  • MAINTENANCE SERVICE Free maintenance services including spares shall be provided by the vendor during the period of warranty. User, at its discretion may ask the vendor to provide maintenance services after warranty period, i.e. Annual maintenance and repairs of the system at the rates indicated by bidder in its proposal and on being asked so, the vendor shall provide the same. The cost of annual maintenance and repairs cost (after warranty period), which will include cost of spares replaced, shall be paid in equal quarterly installments at the end of each quarter.

  • Preventive Maintenance The Contractor shall provide necessary preventive maintenance, required testing and inspection, calibration and/or other work necessary to maintain the equipment in complete operational condition during the warranty period.

  • Hardware Maintenance Hardware Purchased from NCR Voyix or a Reseller is eligible for coverage under NCR Voyix’s Hardware Maintenance Policy for an additional monthly fee, provided however, that some restrictions apply. Subscribed Hardware includes Hardware Maintenance at no additional charge, subject to timely payment of all fees. Provided that you are current on your payment obligations and otherwise in compliance with this Agreement, your Hardware Maintenance includes remote maintenance services and support via telephone, email or live text or chat on the terms stated at the Account Portal (you acknowledge that third-party message and data rates may apply). NCR Voyix’s now-current Hardware Maintenance Policy can be found at ▇▇▇▇▇://▇▇▇.▇▇▇▇▇▇▇▇.▇▇▇/dam/restaurant/docs/ncr-us- merchant-hw-maintenance-policy-ac.pdf.

  • Support and Maintenance Services Information about Teradici’s support and maintenance for the Licensed Product may be found at ▇▇▇▇▇://▇▇▇▇.▇▇▇▇▇▇▇▇.▇▇▇.