Normal Voltage Clause Samples

The 'Normal Voltage' clause defines the standard or expected voltage level at which electrical equipment or systems are designed to operate. In practice, this clause specifies the precise voltage range that is considered acceptable for normal functioning, such as 120V or 240V for household appliances, and may reference industry standards or regulatory requirements. By clearly establishing the baseline voltage, this clause helps ensure equipment compatibility, operational safety, and prevents damage or malfunction due to incorrect voltage supply.
Normal Voltage. The normal voltage at the high side of the main power transformer shall be 110 KV, plus or minus 5 percent.
View SourceView Similar (2)
Normal Voltage. The normal voltage at the high side of the main power transformer shall be determined during preliminary engineering and shown in figure 11, to be attached, with allowance for plus or minus 5 percent.
View SourceView Similar (2)
Normal Voltage. The normal voltage at the high side of the step-up trans­former shall be 138 kV, plus or minus 10.0 percent.
View Source

Related to Normal Voltage

  • Generators Temporary installation of generators, and permanent installation of generators that are placed inside existing non-residential buildings or that occupy an area under 50 square feet behind the building they serve.

  • FREQUENCY AND CAPACITY LEVELS No restriction on frequency, capacity or aircraft types

  • Switching System Hierarchy and Trunking Requirements For purposes of routing ECI traffic to Verizon, the subtending arrangements between Verizon Tandem Switches and Verizon End Office Switches shall be the same as the Tandem/End Office subtending arrangements Verizon maintains for the routing of its own or other carriers’ traffic (i.e., traffic will be routed to the appropriate Verizon Tandem subtended by the terminating End Office serving the Verizon Customer). For purposes of routing Verizon traffic to ECI, the subtending arrangements between ECI Tandem Switches and ECI End Office Switches shall be the same as the Tandem/End Office subtending arrangements that ECI maintains for the routing of its own or other carriers’ traffic.

  • Electrical Equipment Residents must use only CSA, UL-approved or Canadian-certified electrical equipment; the rated wattage of light fixtures must never be exceeded; and only replacement bulbs supplied by Waterloo maintenance staff may be used. Do not leave any unattended electrical equipment turned on (i.e. hair straighteners, lights etc.)

  • Under-Frequency and Over Frequency Conditions The New York State Transmission System is designed to automatically activate a load- shed program as required by the NPCC in the event of an under-frequency system disturbance. Developer shall implement under-frequency and over-frequency relay set points for the Large Generating Facility as required by the NPCC to ensure “ride through” capability of the New York State Transmission System. Large Generating Facility response to frequency deviations of predetermined magnitudes, both under-frequency and over-frequency deviations, shall be studied and coordinated with the NYISO and Connecting Transmission Owner in accordance with Good Utility Practice. The term “ride through” as used herein shall mean the ability of a Generating Facility to stay connected to and synchronized with the New York State Transmission System during system disturbances within a range of under-frequency and over-frequency conditions, in accordance with Good Utility Practice and with NPCC Regional Reliability Reference Directory # 12, or its successor.