Riparian Management Areas Sample Clauses

Riparian Management Areas. The Riparian Management Area is the primary focus of the management measures and restoration actions contained in a Riparian Management Agreement.
Riparian Management Areas. ‌ The IFPA developed a comprehensive riparian layer involving a number of data sources including Forest Cover, TRIM, PEM/TEM mapping and digital orthophotos. The intent of this process was to capture all lakes, rivers and wetlands that exist in the ▇▇▇▇▇▇ TSA so that they were adequately inventoried and accounted for. These riparian areas were then classified and buffered according to the Forest Practices and Range Act standards (Table 19). Reductions to the timber harvesting land base will not be applied for riparian classes where a riparian reserve zone is not required (e.g. S4 streams) as current practices in these riparian areas mainly consist in retaining non-merchantable conifer trees, deciduous trees, shrubs, and herbaceous vegetation within 10 metres of the channel or edge. A review of approved Forest Development Plan (FDP) in the ▇▇▇▇▇▇ TSA indicates that the level of retention in RMZ for all riparian classes varies from site to site from a minimum of 0% basal area retention to a maximum of 100%. Proposed Forest Stewardship Plans (FSP) and some approved FDPs, indicate that a minimum of 25% of the RMZ will be retained where a RRZ is required. Therefore, considering the above and the recommendations contained in the Riparian Management Guidebook, the reduction percentages indicated above will be used for this determination. Stream Class Description Riparian Reserve Zone (m) Reduction % Management Zone Width (m) Reduction % S1 Fish stream, width > 20m 50 100 20 50 S2 Fish stream, width > 5m 30 100 20 50 S3 Fish stream, with >1.5 m 20 100 20 50 L1 Lake between 5 – 1000 ha 10 100 0 0 W1 Wetland >5 ha 10 100 40 25 W5 Complex of wetlands 10 100 40 25 The following table (Table 20) lists the areas that are a reduction to the volume based tenure agreement lands since they are riparian management areas.

Related to Riparian Management Areas

  • Stormwater Management a) The Owner AGREES to implement the requirements incorporated in the Draft Plan Conditions attached as Schedule “F” and any reports submitted to Kawartha Region Conservation Authority and the City pertaining to: i) pre and post development run-off flows and water balance calculations, and the intended means of conveying stormwater flow from each Lot, Block and the entire proposed Plan of Subdivision; ii) the anticipated impact of the Plan of Subdivision on water quality and phosphorus control, as it relates to fish and fish habitat once adequate protective measures have been taken; iii) the means whereby erosion and sedimentation and their effects will be minimized on the site during and after construction; iv) the site soil conditions, including grain size distribution profiles; v) a site grading plan. b) The Owner AGREES to erect and maintain all stormwater management and erosion and sedimentation control structures operating and in good repair during the construction period, in a manner satisfactory to Kawartha Region Conservation Authority and the City. c) Prior to the execution of this Agreement, the Owner AGREES to confirm to the City that Conservation Authority has reviewed and approved the stormwater management report and plan, erosion and sedimentation plan, and final Lot Grading Plans as required under this Section. a) UPGRADES TO EXISTING STORM SEWER b) UPGRADES TO EXISTING SANITARY SEWER

  • Alpine Areas As of 1 March 2024, the Employer shall pay an Alpine disability allowance of $4.45 for hours worked on Projects in alpine areas. These allowances will be adjusted annually in accordance with CPI (All Groups, Melbourne) movements measured in the twelve month period ending the previous December quarter effective as of 1 March 2025, rounded to the nearest 5 cents.

  • Drainage Systems (1) Clear culvert inlets, outlets, and sediment catching basins. (2) Maintain waterbars, drainage dips, and other water diversion measures. (3) During active use, patrol and maintain functional drainage. (4) Repair damaged culvert ends.

  • Wastewater investments in the construction, material enhancement, or renewal of infrastructure that supports wastewater and storm water collection, treatment, and management systems. Note: Investments in health infrastructure (e.g., hospitals, long-term care facilities, convalescent centres, and senior centres) are not eligible. Eligible Expenditures will be limited to the following: 1. Infrastructure investments – expenditures associated with acquiring, planning, designing, constructing, or renovating a tangible capital asset and any related debt financing charges specifically identified with that asset. 2. Capacity-building costs – for projects eligible under the capacity-building category only, expenditures associated with the development and implementation of: • Capital investment plans, integrated community sustainability plans, integrated regional plans, housing needs assessments, or asset management plans; • Studies, strategies, systems, software, third-party assessments, plans, or training related to asset management; • Studies, strategies, systems, or plans related to housing or land use; • Studies, strategies, or plans related to the long-term management of infrastructure; and • Other initiatives that strengthen the Recipient’s ability to improve local and regional planning. 3. Joint communications and signage costs – expenditures directly associated with joint federal communication activities and with federal project signage.

  • Underground Facilities All underground pipelines, conduits, ducts, cables, wires, manholes, vaults, tanks, tunnels, or other such facilities or attachments, and any encasements containing such facilities, including without limitation those that convey electricity, gases, steam, liquid petroleum products, telephone or other communications, cable television, water, wastewater, storm water, other liquids or chemicals, or traffic or other control systems.