Running of Locomotive Engineers Clause Samples

Running of Locomotive Engineers. In Regularly
View SourceView Similar (5)
Running of Locomotive Engineers. NOTE: The following Article 25.1 is applicable in Districts 1, 2, 3, 4 and 6 only 25.1 Provided that the employee filling the vacancy of locomotive engineer is not restricted from working the position of In-charge locomotive engineer, the following procedure will (a) When a regularly assigned locomotive engineer is absent for any reason, on a tour of duty basis, the other assigned locomotive engineer will determine the designation, except when the spare locomotive engineer called for the assignment is senior to the assigned locomotive engineer, the spare locomotive engineer will determine the designation. (b) When a VIA locomotive engineer is working with a CN locomotive engineer the VIA locomotive engineer will determine the designation. (c) When two spare locomotive engineers are called for an assignment, the senior locomotive engineer will determine the designation. 25.2 Except as provided in Articles 25.8 and 25.10, locomotive engineers in regularly assigned service will, if available, follow their assignment.
View SourceView Similar (2)
Running of Locomotive Engineers. NOTE: The following Article 25.1 is applicable in Districts 1, 2, 3, 4 and 6 only 25.1 Provided that the employee filling the vacancy of locomotive engineer is not restricted from working the position of In-charge locomotive engineer, the following procedure will apply in determining the designation of In-charge locomotive engineer or Operating locomotive engineer in road service. (a) When a regularly assigned locomotive engineer is absent for any reason, on a tour of duty basis, the other assigned locomotive engineer will determine the designation, except when the spare locomotive engineer called for the assignment is senior to the assigned locomotive engineer, the spare locomotive engineer will determine the designation. (b) When a VIA locomotive engineer is working with a CN locomotive engineer the VIA locomotive engineer will determine the designation. (c) When two spare locomotive engineers are called for an assignment, the senior locomotive engineer will determine the designation. 25.2 Except as provided in Articles 25.8 and 25.10, locomotive engineers in regularly assigned road service will, if available, follow their assignment.
View Source

Related to Running of Locomotive Engineers

  • Computer Equipment Recycling Program If this Contract is for the purchase or lease of computer equipment, then Contractor certifies that it is in compliance with Subchapter Y, Chapter 361 of the Texas Health and Safety Code related to the Computer Equipment Recycling Program and the Texas Commission on Environmental Quality rules in 30 TAC Chapter 328.

  • Testing of Metering Equipment Connecting Transmission Owner shall inspect and test all of its Metering Equipment upon installation and at least once every two (2) years thereafter. If requested to do so by NYISO or Developer, Connecting Transmission Owner shall, at Developer’s expense, inspect or test Metering Equipment more frequently than every two (2) years. Connecting Transmission Owner shall give reasonable notice of the time when any inspection or test shall take place, and Developer and NYISO may have representatives present at the test or inspection. If at any time Metering Equipment is found to be inaccurate or defective, it shall be adjusted, repaired or replaced at Developer’s expense, in order to provide accurate metering, unless the inaccuracy or defect is due to Connecting Transmission Owner’s failure to maintain, then Connecting Transmission Owner shall pay. If Metering Equipment fails to register, or if the measurement made by Metering Equipment during a test varies by more than two percent from the measurement made by the standard meter used in the test, Connecting Transmission Owner shall adjust the measurements by correcting all measurements for the period during which Metering Equipment was in error by using Developer’s check meters, if installed. If no such check meters are installed or if the period cannot be reasonably ascertained, the adjustment shall be for the period immediately preceding the test of the Metering Equipment equal to one-half the time from the date of the last previous test of the Metering Equipment. The NYISO shall reserve the right to review all associated metering equipment installation on the Developer’s or Connecting Transmission Owner’s property at any time.

  • All new supplies equipment and services shall include manufacturer's minimum standard warranty unless otherwise agreed to in writing. Vendor shall be legally permitted to sell all products offered for sale to TIPS Members. All goods proposed and sold shall be new unless clearly stated in writing. The Vendor shall provide timely and accurate customer support for orders to TIPS Members as agreed by the Parties. Vendors shall respond to such requests within a commercially reasonable time after receipt of the request. If support andƒor training is a line item sold or packaged with a sale, support shall be as agreed with the TIPS Member. Most TIPS Members are tax exempt and the related laws andƒor regulations of the controlling jurisdiction(s) of the TIPS Member shall apply. No assignment of Agreement may be made without the prior notification of TIPS. Written approval of TIPS shall not be unreasonably withheld. Payment for delivered goods and services can only be made to the awarded Vendor, Vendor designated reseller or vendor assigned company.

  • PREVAILING WAGE RATES - PUBLIC WORKS AND BUILDING SERVICES CONTRACTS If any portion of work being Bid is subject to the prevailing wage rate provisions of the Labor Law, the following shall apply:

  • Required Procurement Procedures for Obtaining Goods and Services The Grantee shall provide maximum open competition when procuring goods and services related to the grant- assisted project in accordance with Section 287.057, Florida Statutes.