Stability and Movement Joints Clause Samples

Stability and Movement Joints. 2.5.1 Stability Lateral stability to the building is provided by reinforced concrete lift shaft walls and the moment frame action of the southern spine beams and columns. The steel roof is stabilised by a combination of bracing down to the supporting concrete slab and cantilever action of to columns.

Related to Stability and Movement Joints

  • Drug-Free Workplace Certification As required by Executive Order No. 90-5 dated April 12, 1990, issued by the Governor of Indiana, the Company hereby covenants and agrees to make a good faith effort to provide and maintain a drug-free workplace at the Project Location. The Company will give written notice to the IEDC within ten (10) days after receiving actual notice that the Company, or an employee of the Company in the State of Indiana, has been convicted of a criminal drug violation occurring in the workplace. False certification or violation of this certification may result in sanctions including, but not limited to, suspension of payments under the Agreement, termination of the Agreement and/or debarment of contracting opportunities with the State for up to three (3) years. In addition to the provisions of the above paragraph, if the total amount set forth in the Agreement is in excess of $25,000.00, the Company agrees that it will provide a drug-free workplace by: A. Publishing and providing to all of its employees a statement notifying them that the unlawful manufacture, distribution, dispensing, possession or use of a controlled substance is prohibited in the Company’s workplace, and specifying the actions that will be taken against employees for violations of such prohibition;

  • Musculoskeletal Injury Prevention and Control The hospital in consultation with the Joint Health and Safety Committee (JHSC) shall develop, establish and put into effect, musculoskeletal prevention and control measures, procedures, practices and training for the health and safety of employees.

  • Minimum Site Requirements for TIPS Sales (when applicable to TIPS Sale). Cleanup: When performing work on site at a TIPS Member’s property, Vendor shall clean up and remove all debris and rubbish resulting from their work as required or directed by the TIPS Member or as agreed by the parties. Upon completion of work, the premises shall be left in good repair and an orderly, neat, clean and unobstructed condition. Preparation: Vendor shall not begin a project for which a TIPS Member has not prepared the site, unless Vendor does the preparation work at no cost, or until TIPS Member includes the cost of site preparation in the TIPS Sale Site preparation includes, but is not limited to: moving furniture, installing wiring for networks or power, and similar pre‐installation requirements. Registered Sex Offender Restrictions: For work to be performed at schools, Vendor agrees that no employee of Vendor or a subcontractor who has been adjudicated to be a registered sex offender will perform work at any time when students are, or reasonably expected to be, present unless otherwise agreed by the TIPS Member. Vendor agrees that a violation of this condition shall be considered a material breach and may result in the cancellation of the TIPS Sale at the TIPS Member’s discretion. Vendor must identify any additional costs associated with compliance of this term. If no costs are specified, compliance with this term will be provided at no additional charge. Safety Measures: Vendor shall take all reasonable precautions for the safety of employees on the worksite, and shall erect and properly maintain all necessary safeguards for protection of workers and the public. Vendor shall post warning signs against all hazards created by the operation and work in progress. Proper precautions shall be taken pursuant to state law and standard practices to protect workers, general public and existing structures from injury or damage. Smoking: Persons working under Agreement shall adhere to the TIPS Member’s or local smoking statutes, codes, ordinances, and policies.

  • Project Monitoring Reporting and Evaluation The Recipient shall furnish to the Association each Project Report not later than forty-five (45) days after the end of each calendar semester, covering the calendar semester.

  • Scope of Cooperation 1. The Authorities recognise the importance of close communication concerning the Covered CCPs and intend to cooperate regarding: a) general issues, including with respect to regulatory, supervisory, enforcement or other developments concerning the Covered CCPs and Australia; b) issues relevant to the operations, activities and services of the Covered CCPs; c) the coordination of supervisory activities and, where appropriate and consistent with applicable laws and each Authority’s mandate, providing assistance in the implementation of enforcement decisions; d) any other areas of mutual interest. 2. The Authorities recognise in particular the importance of close cooperation in the event that a Covered CCP, particularly one whose failure likely would be systemically important to an Authority, experiences, or is threatened by, a potential financial crisis or other Emergency Situation. One or both of the Local Authorities should provide notification to ESMA, and ESMA should provide notification to the Local Authorities, consistent with Article 3(4) below and each Authority should keep the other Authorities appropriately informed throughout the Emergency Situation. The Local Authorities should coordinate and lead in an Emergency Situation and should consult with and take account of the views of ESMA to the greatest extent practicable. ESMA should coordinate with the relevant CBI(s) regarding an Emergency Situation of a Covered CCP and any emergency measures that the CBI may consider appropriate. 3. Cooperation will be most useful in circumstances where issues of regulatory, supervisory or enforcement concern may arise, including but not limited to: a) the initial application of a Covered CCP for recognition in the European Union pursuant to Article 25 of EMIR and the periodic reviews of its recognition pursuant to Article 25(5) of EMIR; b) ESMA’s assessment of compliance and monitoring of the ongoing compliance by a Covered CCP with the Recognition Conditions; c) the tiering determination of a Covered CCP by ESMA pursuant to Article 25(2a) of EMIR; d) changes in a Covered CCP's internal rules, policies and procedures that could affect the way in which the Covered CCP complies with any Recognition Conditions; e) regulatory, supervisory or enforcement actions or approvals taken by a Local Authority or ESMA in relation to a Covered CCP, including changes to the relevant obligations and requirements to which the Covered CCPs are subject that may impact the Covered CCPs' continued compliance with the Recognition Conditions; and f) changes to regulatory status or requirements that could result in a change in the regulatory status of, relief granted to, or supervisory treatment of a Covered CCP and potentially could disrupt cross-border clearing arrangements.