System Conditions Sample Clauses

The 'System Conditions' clause defines the required operational state or parameters that a system must meet for contractual obligations to be fulfilled. It typically outlines specific technical, environmental, or performance criteria—such as minimum uptime, software version requirements, or network connectivity—that must be maintained. By clearly specifying these conditions, the clause ensures both parties understand the baseline requirements for system functionality, thereby reducing disputes and clarifying responsibilities if issues arise.
System Conditions. The CAISO shall monitor and observe real time system conditions throughout the CAISO Controlled Grid, as well as key facilities in other areas of the WECC region.
View SourceView Similar (17)
System Conditions. The ISO shall monitor and observe real time system conditions throughout the ISO Controlled Grid, as well as key facilities in other areas of the WSCC region.
View SourceView Similar (6)
System Conditions. An ETG System is authorized when the ETG System does not allow a patron to play a device prohibited by RCW 9.46.0233(1)(b) and RCW 67.70.040(1)(a) (“Play Against the Machine”). An ETG System does not allow Play Against the Machine when: DRAFT 3.2.1 there is a human dealer involved in the play of the ETG (“Dealer Controlled”); or 3.2.2 the play of the ETG does not involve a human dealer, and the ETG System is configured for play between two or more patrons against the same roll of dice or spin of the wheel, or a Communal Shoe of electronic cards (“Non-Dealer Controlled”); however, only one patron is needed to initiate game play; or 3.2.3 it is a hybrid of Dealer Controlled and Non-Dealer Controlled, provided that any ETG played as Dealer Controlled follows applicable Dealer-Controlled standards set forth in this Appendix and any ETG offered as Non-Dealer Controlled follows applicable Non-Dealer Controlled standards set forth in this Appendix.
View SourceView Similar (6)
System Conditions. The parties recognize that moisture, pressure, or other conditions within the system may prevent available metering equipment from maintaining proper calibrations. If such conditions persist, the parties will attempt to determine by mutual agreement a protocol for estimating Landfill Gas and Biomethane deliveries using such data as is available. If the parties cannot so mutually agree, they will appoint a mutually acceptable third party consultant and will share equally the cost of such consultant, and will accept the recommendations of such consultant in estimating Biomethane and Landfill Gas deliveries thereafter.
View Source

Related to System Conditions

  • Unsafe Conditions In accordance with 29 CFR § 1977, occasions might arise when an employee is confronted with a choice between not performing assigned tasks or subjecting himself/herself to serious injury or death arising from a hazardous condition at the workplace. If the employee, with no reasonable alternative, refuses in good faith to expose himself/herself to the dangerous condition, he/she would be protected against subsequent discrimination. The condition causing the employee's apprehension of death or injury must be of such a nature that a reasonable person, under the circumstances then confronting the employee, would conclude that there is a real danger of death or serious injury and that there is insufficient time, due to the urgency of the situation, to eliminate the danger by resorting to regular statutory enforcement channels. In addition, in such circumstances, the employee, where possible, must also have sought from his Employer, and been unable to obtain, a correction of the dangerous condition.

  • Unsafe Work Conditions No Employee shall be disciplined for refusal to work on a job which in the opinion of: (a) A member of a safety committee; or (b) A person designated by a safety committee; or (c) A safety officer after an on-site inspection and following discussion with a representative of the Employer, does not meet the standards established pursuant to the Workers' Compensation Act.

  • Work Conditions The Contractor agrees to accept sole responsibility to comply with all federal, provincial and municipal legislation which may have application to the Work and agrees to comply with all provincial and federal legislation affecting conditions of work and wage rates including the Employment Standards Act R.S.P.E.I. 1988, Cap. E-6.2, the Workers Compensation Act R.S.P.E.I. 1988, Cap. W-7.1, or any other laws that impose obligations in the nature of employers’ obligations. The Contractor agrees to follow the Public Service Commission Human Resource Policies 9.05 Violence in the Workplace Policy; 9.08 Drug, Alcohol, and Medication Policy, and 11.01 Policy for the Prevention and Resolution of Harassment in the Workplace while working on Government sites, in Government vehicles or alongside Government staff. The Contractor agrees to accept the full cost of doing those things required under this paragraph and will not charge or seek reimbursement from the Owner in any way, such costs having been taken into consideration and included in the rates of payment stipulated in this Agreement.

  • Safe Conditions Whenever an employee reports a condition which the employee feels represents a violation of safety or health rules and regulations or which is an unreasonable hazard to persons or property, such conditions shall be promptly investigated. The appropriate administrator shall reply to the concern, in writing, if the employee's concern is communicated in writing.

  • Service Conditions Customer acknowledges that in the event of a service issue, Customer is responsible for on-site cooperative testing with LightEdge Technical Support to assist in the diagnosis of the trouble. Customer agrees to be bound to current terms of LightEdge Acceptable Use Policy. Terms of the Acceptable Use Policy are subject to change without notice. Current Acceptable Use Policy can be found here: ▇▇▇▇://▇▇▇.▇▇▇▇▇▇▇▇▇.▇▇▇/legal Customer agrees that any service complaints including concerns regarding level of support, products, service reliability, or any other concerns related to LightEdge or Services being provided by LIghtEdge will be communicated to LightEdge by sending an email to ▇▇@▇▇▇▇▇▇▇▇▇.▇▇▇.