Common use of Technical Standards and Regulations Clause in Contracts

Technical Standards and Regulations. The design, the Contractor´s Documents, the execution and the completed Works shall comply with the Country´s technical standards, building, construction and environmental Laws, Laws applicable to the product being produced from the Works, and other standards specified in the Employer´s Requirements, applicable to the Works, or defined by the applicable Laws. All these Laws shall, in respect of the Works and each Section, be those prevailing when the Works or Section are taken over by the Employer under Clause 10 [Employer's Taking Over]. References in the Contract to published standards shall be understood to be references to the edition applicable on the Base Date, unless stated otherwise. If changed or new applicable standards come into force In the Country after the Base Date, the Contractor shall give notice to the Engineer and (if appropriate) submit proposals for compliance. In the event that: (a) the Engineer determines that compliance is required, and (b) the proposals for compliance constitute a variation, then the Engineer shall initiate a Variation in accordance with Clause 13 [Variations and Adjustments].

Technical Standards and Regulations. The design, the Contractor´s Contractor's Documents, the execution and the completed Works shall comply with the Country´s Country’s technical standards, building, construction and environmental Laws, Laws applicable to the product being produced from the Works, and other standards specified in the Employer´s Employer's Requirements, applicable to the Works, or defined by the applicable Laws. All these Laws shall, in respect of the Works and each Section, be those prevailing when the Works or Section are taken over by the Employer under Clause 10 [Employer's ’s Taking Over]. References in the Contract to published standards shall be understood to be references to the edition applicable on the Base Date, unless stated otherwise. If changed or new applicable standards come into force In in the Country after the Base Date, the Contractor shall give notice to the Engineer and (if appropriate) submit proposals for compliance. In the event that: (a) the Engineer determines that compliance is required, and (b) the proposals for compliance constitute a variation, then the Engineer shall initiate a Variation in accordance with Clause 13 [Variations and Adjustments].

Technical Standards and Regulations. The design, the Contractor´s Contractor's Documents, the execution and the completed Works shall comply with the Country´s Country‟s technical standards, building, construction and environmental Laws, Laws applicable to the product being produced from the Works, and other standards specified in the Employer´s Employer's Requirements, applicable to the Works, or defined by the applicable Laws. All these Laws shall, in respect of the Works and each Section, be those prevailing when the Works or Section are taken over by the Employer under Clause GCC 10 [Employer's Employer‟s Taking Over]. References in the Contract to published standards shall be understood to be references to the edition applicable on the Base Date, unless stated otherwise. If changed or new applicable standards come into force In in the Country after the Base Date, the Contractor shall give notice to the Engineer Project Manager and (if appropriate) submit proposals for compliance. In the event that: : (a) the Engineer Project Manager determines that compliance is required, and and (b) the proposals for compliance constitute a variation, then the Engineer shall Project Manager may initiate a Variation in accordance with Clause GCC 13 [Variations [ Variation s and Adjustments].