Common use of Test apparatus Clause in Contracts

Test apparatus. 2.1.1. This consists of cylindrical surfaces with a radius of curvature equal to 82 ± 3 mm and a width: 2.1.1.1. At least equal to the width of the seat-back of each seating position of the seat to be tested for the upper form; 2.1.1.2. Equal to 320 -0/+10 mm for the lower form as shown in Figure 1 of this appendix. 2.1.2. The surface resting against the parts of the seat shall be made of a material the hardness of which is not less than 80 Shore A. 2.1.3. Each cylindrical surface shall be equipped with at least one force transducer able to measure the forces applied in the direction defined in paragraph 2.2.1.1.

Test apparatus. 2.1.1. This consists of cylindrical surfaces with a radius of curvature equal to 82 ± 3 mm and a width: 2.1.1.1. At least equal to the width of the seat-back of each seating position of the seat to be tested for the upper form; , 2.1.1.2. Equal to 320 -0/+10 mm for the lower form as shown in Figure 1 of this appendix. 2.1.2. The surface resting against the parts of the seat shall be made of a material the hardness of which is not less than 80 Shore A. 2.1.3. Each cylindrical surface shall be equipped with at least one force transducer able to measure the forces applied in the direction defined in paragraph 2.2.1.1.

Test apparatus. 2.1.1. This consists of cylindrical surfaces with a radius of curvature equal to 82 ± + 3 mm and a width: 2.1.1.1. At at least equal to the width of the seat-back of each seating position of the seat to be tested for the upper form;, 2.1.1.2. Equal equal to 320 -0/+10 mm for the lower form as shown in Figure 1 of this appendix. 2.1.2. The surface resting against the parts of the seat shall be made of a material the hardness of which is not less than 80 Shore A. 2.1.3. Each cylindrical surface shall be equipped with at least one force transducer able to measure the forces applied in the direction defined in paragraph 2.2.1.1.

Test apparatus. 2.1.1. This consists of cylindrical surfaces with a radius of curvature equal to 82 ± + 3 mm and a width: 2.1.1.1. At at least equal to the width of the seat-back of each seating position of the seat to be tested for the upper form; , 2.1.1.2. Equal equal to 320 -0/+10 mm for the lower form as shown in Figure 1 of this appendix. 2.1.2. The surface resting against the parts of the seat shall be made of a material the hardness of which is not less than 80 Shore A. 2.1.3. Each cylindrical surface shall be equipped with at least one force transducer able to measure the forces applied in the direction defined in paragraph 2.2.1.1.