Doors, Windows and Glass Clause Samples

Doors, Windows and Glass. All insulated glass will be 1” reflective glass or Low E with a shading coefficient of no greater than 0.30. All aluminum curtainwall/vertical butt-glazed or captured strip window/ punched window systems are to be standard construction using Vistawall, Kawneer, or equal with standard anodized or factory painted finishes and extruded metal window ▇▇▇▇▇. All window systems shall be thermally improved with a minimum 68.5 CRF. All windows are to be recessed a minimum of 2” from the face of the precast or masonry skin. Each manufacturer should warrant that its material is compatible in the “system” as installed that is, caulking, rubber gaskets etc. Entrances and storefronts shall have a 2-year manufacturer and contractor co-warranty. Automatic operators for handicapped access shall be used as required. Provide air lock at entry. Window system Shop Drawings are to be reviewed by a curtainwall consultant employed by Owner. All submittals shall conform to the following checklist.
View SourceView Similar (2)
Doors, Windows and Glass. 810 INTERIOR DOORS • Tenant Improvement: o All interior doors to be keyed to building master. o All rated doors, frames, and hardware shall be UL listed.
View Source
Doors, Windows and Glass 
View SourceView Similar (2)

Related to Doors, Windows and Glass

  • Windows a. Front and rear windshield per California Vehicle Code § 26710. b. Safety glass shall be in all windows. c. Windows shall be operational as originally designed. d. No window tinting on windshield or front side windows per California Vehicle Code § 26708. Any tinting applied to the rear side or rear windows must be light enough to allow any passengers to be viewed from the outside.

  • GLASS Coverage is provided for all loss or damages to exterior glass, lettering, ornamentation and burglar foils thereon, caused by accidental breakage of such glass. The Insurer shall not be liable under this Additional Agreement for coverage for: a) loss or damage directly or indirectly from fire whether in the “premises” described in the “Declaration Page” or elsewhere; b) loss or damage caused directly or indirectly by the perils excluded in Perils Excluded section 6.B of the Commercial Property Broad Form (CMF-0005-1218); c) the cost of removing or replacing any fixtures or other obstructions to the replacement of the glass.

  • Doors Exterior doors may not be propped open for safety and security reasons. Students may be referred to the student conduct system if found propping these doors. Doors marked as emergency exits may only be used for emergency purposes other than during University-sanctioned move-in days.

  • Exterior and interior functional areas and spaces of the Project, with technical and equipment requirements on each;

  • Walls 12 Developer shall provide rustication patterns on all walls, except drainage headwalls, in Aesthetic 13 Area 3 in accordance with Exhibit L2.24 of the LAADCR. The final designs shall resemble these 14 simulations.