Ethernet Sample Clauses

Ethernet. Provide three (3) separate CAT-5E cables to each register (one for the register; one for the pin pad; and, one for the SSA panic button). Run cables to the router cabinet in the Wholesale Area. Lessor to provide cable terminations at the registers. ▇▇▇▇ locations to be determined by the PLCB. Cable terminations and final connections at the router cabinet will be by the PLCB.

Ethernet. The engineering, installation, maintenance and repair services provided by altafiber to Customer necessary to interconnect multiple LANs to form a MAN for data transmission.

Ethernet. 10BaseT (RJ-45) - For LAN or Broadband connection Optional component loads in manufacturing. OS and application automatically senses the absence of the Ethernet chip and does not continually attempt to function. Consider Cirrus Logic "Crystal" series - CS8952 controller + 20Meg Xtal Consider "F1Mag" for Transformer Throughput must be reasonable speed Discuss an "LED" indication of 10BT connection

Ethernet. Testing shall be clear channel, head-to-head cooperative testing. Testing shall run over a twenty-four (24) hour period mutually agreed upon by the parties. Customer shall accept the Service when it is error-free over any twenty-four (24) hour period.

Ethernet. A. The Ethernet circuit will be terminated as a full-duplex connection at the port speed marked above. It is Customer’s responsibility to ensure that their equipment can handle this connection. B. It is highly recommended that the Customer’s equipment supports shaping on the egress, and that this capability is activated and set to the purchased transport speed. C. The Customer is responsible for avoiding bridging loops between Ethernet connected networks. D. All Ethernet transport will have a Maximum Transmission Unit (MTU) size of 2000 bytes.

Ethernet. 2.2.1. Ethernet Access Circuits will be either 10, 100 or 1000Mbps rate limited at increments to be agreed with You and specified in the Order. 2.2.2. The standard presentation will be a router port into which You will connect a 10/100/1000 Mbps Ethernet LAN cable. 2.2.3. Ethernet will use 1000Base-T (Copper) as standard, Fibre options (SX/LX) are available however may incur additional charges.

Ethernet. This is the most reliable connection option if you can run the supplied 1.5-meter Ethernet cable directly from your modem to your Set Top Box. For greater distances, you can use your own Ethernet cable, but you are responsible for any equipment supplied by you.

Ethernet. If the distance is greater than 2 metres but less than 5 metres, you can purchase your own Ethernet cable, but we do not accept responsibility for any effect a cable we do not supply has on the FetchTV Service.

Ethernet. ‌ The reference board is hooked with an Ethernet 10/100 Mbps connection. To measure the board 100 Mbps Ethernet performance, theoretically, a timer with around 6.4us is required. (84 Bytes) / ((100 / 8) * 1024 * 1024) ~= 6,4 Where 84 Bytes size corresponds to the smallest packet sent on the wire. Preamble + SOF + 64 Ethernet packet + Interpacket Gap A one micro second granularity can be achieved using the timer within the reference platform. Benchmarking functionality offers an abstraction in NuttX to make it easier to port it and to use it on every device. Furthermore the benchmarking functionality is included in the Kconfig menu configuration to en- able seamless integration.