For Preliminary Engineering Contracts Clause Samples

For Preliminary Engineering Contracts. (a) To attend meetings and visit the site of the proposed improvement when requested to do so by representatives of the LPA or the DEPARTMENT, as defined in Exhibit A (Scope of Services). (b) That all plans and other documents furnished by the ENGINEER pursuant to the AGREEMENT will be endorsed by the ENGINEER and affixed the ENGINEER's professional seal when such seal is required by law. Such endorsements must be made by a person, duly licensed or registered in the appropriate category by the Department of Professional Regulation of the State of Illinois. It will be the ENGINEER's responsibility to affix the proper seal as required by the Bureau of Local Roads and Streets manual published by the DEPARTMENT. (c) That the ENGINEER is qualified technically and is thoroughly conversant with the design standards and policies applicable for the PROJECT; and that the ENGINEER has sufficient properly trained, organized and experienced personnel to perform the services enumerated in Exhibit A (Scope of Services).
For Preliminary Engineering Contracts. (a) That tracing, plans, specifications, estimates, maps and other documents prepared by the ENGINEER in accordance with this AGREEMENT shall be delivered to and become the property of the LPA and that basic survey notes, sketches, charts, CADD files, related electronic files, and other data prepared or obtained in accordance with this AGREEMENT shall be made available, upon request to the LPA or to the DEPARTMENT, without restriction or limitation as to their use. Any re-use of these documents without the ENGINEER involvement shall be at the LPA's sole risk and will not impose liability upon the ENGINEER. Add Subconsultants (b) That all reports, plans, estimates and special provisions furnished by the ENGINEER shall conform to the current Standard Specifications for Road and Bridge Construction, Bureau of Local Roads and Streets Manual or any other applicable requirements of the DEPARTMENT, it being understood that all such furnished documents shall be approved by the LPA and the DEPARTMENT before final acceptance. During the performance of the engineering services herein provided for, the ENGINEER shall be responsible for any loss or damage to the documents herein enumerated while they are in the ENGINEER's possession and any such loss or damage shall be restored at the ENGINEER's expense. Prime Consultant TIN/FEIN/SS Number Agreement Amount BLA, Inc ▇▇-▇▇▇▇▇▇▇ $633,143.00 Subconsultants TIN/FEIN/SS Number Agreement Amount - ▇▇▇▇▇▇▇▇▇ & Associates, Inc ▇▇-▇▇▇▇▇▇▇ $53,121.00 - Soil and Material Consultants, Inc ▇▇-▇▇▇▇▇▇▇ $34,640.00 Executed by the LPA: County Local Public Agency Type Attest: The of By (Signature & Date) Name of Local Public Agency ▇▇▇▇▇▇▇ By (Signature & Date) ▇▇▇▇▇▇▇ Name of Local Public Agency Local Public Agency Type County Clerk Title County Board Chariman (SEAL) Executed by the ENGINEER: Attest: Consultant (Firm) Name BLA, Inc By (Signature & Date) By (Signature & Date) Title Title CEO / President Vice President Local Public Agency County Section Number County of McHenry ▇▇▇▇▇▇▇ 18-00482-00-BR To perform or be responsible for the performance of the engineering services for the LPA, in connection with the PROJECT herein before described and enumerated below See Attached Exhibit A Route CH T64 – Millstream Road over Kishwaukee River / South Branch Kishwaukee River Local Agency County of McHenry Section 18-00482-00-BR Job No. D-91-001-19 Project No. 8M8X(096) Type of Funding STP-Bridge Exist/Prop. Structure No. 056-3022/056-4022 (North...
For Preliminary Engineering Contracts. (a) That tracing, plans, specifications, estimates, maps and other documents prepared by the ENGINEER in accordance with THIS AGREEMENT shall be delivered to and become the property of the LPA and that basic survey notes, sketches, charts, CADD files, related electronic files, and other data prepared or obtained in accordance with THIS AGREEMENT shall be made available upon request to the LPA without restriction or limitation as to their use. Any re-use of these documents without the ENGINEER involvement shall be at the LPA's sole risk and will not impose liability upon the ENGINEER. (b) That all reports, plans, estimates and special provisions furnished by the ENGINEER shall conform to the DEPARTMENT’s current Standard Specifications for Road and Bridge Construction, Bureau of Local Roads and Streets Manual or any other applicable requirements of the LPA, it being understood that all such furnished documents shall be approved by the LPA before final acceptance. During the performance of the engineering services herein provided for, the ENGINEER shall be responsible for any loss or damage to the documents herein enumerated while they are in the ENGINEER's possession and any such loss or damage shall be restored at the ENGINEER's expense. For Construction Engineering Contracts: (a) That all services are to be furnished as required by construction progress and as determined by the LPA employee In Responsible Charge. The ENGINEER shall complete all services herein within a time considered reasonable to the LPA, after the CONTRACTOR has completed the construction contract. (b) That all field notes, test records and reports shall be turned over to and become the property of the LPA and that during the performance of the engineering services herein provide for, the ENGINEER shall be responsible for any loss or damage to the documents herein enumerated while they are in the ENGINEER's possession and any such loss or damage shall be restored at the ENGINEER's expense. (c) That any differences between the ENGINEER and the LPA concerning the interpretation of the provisions of THIS AGREEMENT shall be referred to a committee of disinterested parties consisting of one member appointed by the ENGINEER, one member appointed by the LPA, and a third member appointed by the two other members for disposition and that the committee's decision shall be final. (d) That in the event that engineering and inspection services to be furnished and performed by the ENGINEER (includin...
For Preliminary Engineering Contracts. (a) That tracing, plans, specifications, estimates, maps and other documents prepared by the ENGINEER in accordance with this AGREEMENT shall be delivered to and become the property of the LPA and that basic survey notes, sketches, charts, CADD files, related electronic files, and other data prepared or obtained in accordance with this AGREEMENT shall be made available, upon request to the LPA or to the DEPARTMENT, without restriction or limitation as to their use. Any re-use of these documents without the ENGINEER involvement shall be at the LPA's sole risk and will not impose liability upon the ENGINEER. (b) That all reports, plans, estimates and special provisions furnished by the ENGINEER shall conform to the current Standard Specifications for Road and Bridge Construction, Bureau of Local Roads and Streets Manual or any other applicable requirements of the DEPARTMENT, it being understood that all such furnished documents shall be approved by the LPA and the DEPARTMENT before final acceptance. During the performance of the engineering services herein provided for, the ENGINEER shall be responsible for any loss or damage to the documents herein enumerated while they are in the ENGINEER's possession and any such loss or damage shall be restored at the ENGINEER's expense.

Related to For Preliminary Engineering Contracts

  • Architect/Engineer (A/E) means a person registered as an architect pursuant to Tex. Occ. Code ▇▇▇., Chapter 1051, as a landscape architect pursuant to Tex. Occ. Code ▇▇▇., Chapter 1052, a person licensed as a professional engineer pursuant to Tex. Occ. Code ▇▇▇., Chapter 1001 and/or a firm employed by Owner or a design-build contractor to provide professional architectural or engineering services and to exercise overall responsibility for the design of a Project or a significant portion thereof, and to perform the contract administration responsibilities set forth in the Contract.

  • Geotechnical Engineer « »« » « » « » « » « »

  • Reverse Engineering The Customer must not reverse assemble or reverse compile or directly or indirectly allow or cause a third party to reverse assemble or reverse compile the whole or any part of the software or any products supplied as a part of the Licensed System.

  • Construction Schedule The progress schedule of construction of the Project as provided by Developer and approved by District.