Gaskets Sample Clauses
POPULAR SAMPLE Copied 1 times
Gaskets. Gaskets and O-rings for water service shall be made of Nitrile rubber and readymade matching with respective flanges. Gaskets and O-rings for chemical service including chlorine shall be made of EPDM or Viton. Gaskets cut out from rubber sheets are not acceptable.
Gaskets. Gaskets used with push-on joints for DI pipes shall be provided by the Employer along with pipes at 5% in excess of number of pipes. Additional gaskets for jointing of specials, mechanical joints and extra quantity required for cut pipes etc. over and above that provided by the Employer, shall be supplied by the contractor under this contract along with specials. Rubber gaskets used with push-on joints and mechanical joints shall conform to IS: 5382. Rubber gaskets for use with flange joints shall conform to IS: 638. While conveying potable water the gaskets should not deteriorate the quality of water and should not impart any bad test or foul odor.
Gaskets. Seals; Belts; Hoses; Opened kits; Items made to order; Non-Sandvik Goods; Glass.
Gaskets. Gaskets for flanged, mechanical joint restrained joint and push-on ductile iron pipe shall meet the requirements of ANSI/AWWA Specification ANSI A21.11 / AWWA C111 latest revision. Gasket materials for various service conditions shall be as follows:
1. Air and Water service (up to 120°F) - Synthetic Rubber
2. Air and Water service (120°F to 200°F) - Neoprene
3. Wastewater Service - Styrene Butadiene Copolymer (SBR)
Gaskets. Openings shall be in good working order and provide proper seal to prevent passage of air into the unit from outside sources to the extent possible. D.2.1 14 Trailer shall be well insulated. D.2.1
Gaskets. All gaskets shall be ozone resistant Silicone only. The gaskets must have a 1/8 minimum thickness.
Gaskets. Unless otherwise indicated, gaskets shall be neoprene.
Gaskets. 1/16 inch thick preformed neoprene.
Gaskets washers and other seals for pumps, motors, and the like, discs and membranes 0 A FREE
Gaskets. 1. Gaskets shall have relieving grooves to prevent intermixing of fluids and cause leak to flow to outside of unit.
2. One piece molded CLIP-ON NBR gaskets are required and shall fit around both the heat transfer area and the port holes.
3. Gaskets shall not contain adhesives.