REFLECTIVE TAPE Sample Clauses
The REFLECTIVE TAPE clause requires the use of reflective tape on specified equipment, vehicles, or materials to enhance visibility and safety. Typically, this clause outlines the standards for the tape, such as color, width, and placement, and may specify which items must be marked, like construction vehicles or roadside barriers. Its core function is to reduce the risk of accidents by ensuring that objects are easily seen in low-light or hazardous conditions, thereby improving overall site safety.
REFLECTIVE TAPE. Reflective tape shall be 3" x 18" white strips, capable of reflecting white light only, as manufactured by 3M Company or approved equal and shall be applied vertically on the lamppost base facing direction of traffic flow or on shafts facing both directions of traffic flow, where post is within a Jersey barrier. Tapes are for use on Arterial roadways only.
REFLECTIVE TAPE. There shall be 2-inch wide Silver retro-reflective material, with a ¼” Black colored band located on the top and bottom of the Silver Retro-Reflective Material. The Silver retro-reflective with Black edging material shall be laminated to the pigment coated fluorescent yellow side to enhance safety and visibility of the wearer. The reflective properties of the reflective material and configuration shall meet or exceed the EN-471 and ANSI 107-2015 Type P Class 3; Type R Class 3 minimum requirements.
REFLECTIVE TAPE. There shall be 2-inch wide Silver retro-reflective material, with a ¼” Black colored band located on the top and bottom of the Silver Retro-Reflective Material. The Silver retro- reflective with Black edging material shall be laminated to the pigment coated fluorescent yellow side to enhance safety and visibility of the wearer. The reflective properties of the reflective material and configuration shall meet or exceed the EN-471 and ANSI 107-2015 Class E minimum requirements. The placement of reflective material shall consist of a design and pattern that meets all the requirements The garment must have an ANSI 107-2015 Class E pictogram label showing class. Garment shall have a care and content label.
REFLECTIVE TAPE. Reflective tape shall be one of the following or an approved equal: Scotchlite High Intensity Grade Series 2870 Reflexite AP-1000 Scotchlite Diamond Grade LDP Series 3970 T-6500 High Intensity (Type IV) Footings shall be constructed using concrete Class 3000.
REFLECTIVE TAPE. White, Yellow, White and Yellow or White and Red Must comply with CMVSS 108 Conspicuity Systems - Section S5.7 The "D" Sign has been adopted to identify overdimensional vehicles. Use of Wide Load, Long Load or Oversize Load signs is not permitted or recognized as suitable alternatives. The vehicle transporting an overdimensional load must be equipped with warning "D" signs at front and rear which meet the following specifications: Section Widths (cm) • Colour: White level II reflectance and stop sign red (# 712 3M or equivalent)
REFLECTIVE TAPE. Installed on body sides and tailgate. COMPLY A stainless steel tool box, approximately 18"x 18" x 36” shall be installed. COMPLY 3 camera system, one at the rear for backing and one for each wing operation 2” x 12” rough cut oak painted black COMPLY COMPLY There shall be a Whelen model # RIDOTSY1 Super-LED® lighting system installed. The lighting system shall be made and manufactured in the United States of America. The lighting system shall include (2) Micro 400 SS. Each Micro 400 SS shall contain (3) 400 Series Super-LED® Warning Lightheads (Front/Side/Rear) facing that are to be mounted within a 7 gauge stainless steel housing assembly. Each Micro 400 SS shall have 60' of 4/C, 14 Gauge TPE cable. Each rear corner post shall contain (1) 400 VV Series Amber Super-LED® Warning,