Roof Structure and Cladding Clause Samples

Roof Structure and Cladding. A new roof surface of No. 1 Red cedar sawn shingles will be installed. New regletted step flashing in enamelled sheet iron will be installed at the chimney. Refer to section 3.4.2.2 Roof Structure and Cladding in the ▇. ▇▇▇▇▇▇ Plan.
View SourceView Similar (2)
Roof Structure and Cladding. It is expected to be able to retain the Potato and Machinery Barn trusses, beams and rafters as they are, and augment the structure through tension rods or cables, thereby preserving the structurally expressive character of the interior space. It is likely that all of the roof boards will need replacement. A new roof surface of custom long split shakes will be installed. Refer to section 3.4.1.2 Roof Structure and Cladding in the ▇. ▇▇▇▇▇▇ Plan.
View SourceView Similar (2)
Roof Structure and Cladding. A new No. 1 red cedar sawn shingle roof surface will be installed on the farmhouse. New enamelled sheet steel step flashing will be installed on the existing brick chimneys. The fireplace chimney will be braced and moved with the house, but the furnace chimney is too tall and slender to sustain a move and will be dismantled and rebuilt with the original salvaged brick. The fireplace brick chimney will be repointed and cleaned in the relocated location. The fireplace chimney will be set on a new concrete foundation integral to the foundation wall and the furnace chimney will be supported on framing within the attic. Refer to section 3.4.3.2 Roof Structure and Cladding in the ▇. ▇▇▇▇▇▇ Plan.
View SourceView Similar (2)
Roof Structure and Cladding. Cedar shingles or equivalent shall be used as roofing material for the House. The use of materials other than cedar are subject to the review and approval of the City Architect.
View Source
Roof Structure and Cladding. When replacing with new roof, it is recommended to replace with original cedar roofing. The use of materials other than cedar, however, is permitted, subject to the prior review and approval of the City Architect. If asphalt, duroid or laminated fibreglass shingles are proposed, the colour, texture and pattern of the new shingles should provide a sympathetic appearance that is based on the original roof. The ▇▇▇▇▇ troughs and downspouts shall be examined and replaced if necessary. If proposed to be replaced, a simple gutter profile shall be specified to not compromise the historical character of the House.
View Source
Roof Structure and Cladding. When replacing with new roof, the existing roof shall be replaced with original cedar roofing. The ▇▇▇▇▇ troughs and downspouts shall be examined and replaced if necessary. If proposed to be replaced, a simple gutter profile shall be specified to not compromise the historical character of the House.
View Source
Roof Structure and Cladding. Roof cladding is to be replaced with sawn cedar shingles. Pressure treated shingles are approved.
View Source
Roof Structure and Cladding. Repairs and replacement of the cedar shingle roof and structure shall be overseen by an Architect with expertise in the field of heritage restoration. The original roofing, strapping and fastenings are a part of the heritage significance of the building. The original fastenings (i.e. square nails) should be retained and re-used if at all possible, and examples retained and kept on site for the sake of posterity. Structural reinforcement of the roof structure shall not compromise the visual integrity of the existing structure, but shall also be obvious as a later intervention. Any fascia boards showing signs of decay shall be replaced with wood or cementitious boards, and shall be painted prior to installing ▇▇▇▇▇ troughs. The ▇▇▇▇▇ troughs and downspouts attached to the fascia of the lower roof shall be examined and replaced if necessary. A simple gutter profile shall be specified to not compromise the historical character of the building.
View Source

Related to Roof Structure and Cladding

  • Trunk Group Architecture and Traffic Routing 5.2.1 The Parties shall jointly establish Access Toll Connecting Trunks between CLEC and CBT by which they will jointly provide Tandem-transported Switched Exchange Access Services to Interexchange Carriers to enable such Interexchange Carriers to originate and terminate traffic from and to CLEC's Customers. 5.2.2 Access Toll Connecting Trunks shall be used solely for the transmission and routing of Exchange Access and non-translated Toll Free traffic (e.g., 800/888) to allow CLEC’s Customers to connect to or be connected to the interexchange trunks of any Interexchange Carrier that is connected to the CBT access Tandem. 5.2.3 The Access Toll Connecting Trunks shall be one-way or two-way trunks, as mutually agreed, connecting an End Office Switch that CLEC utilizes to provide Telephone Exchange Service and Switched Exchange Access Service in the given LATA to an access Tandem Switch CBT utilizes to provide Exchange Access in the LATA.

  • CONTRACTOR NAME CHANGE An amendment is required to change the Contractor's name as listed on this Agreement. Upon receipt of legal documentation of the name change the State will process the amendment. Payment of invoices presented with a new name cannot be paid prior to approval of said amendment.

  • Contractor Changes The Contractor shall notify DAS in writing no later than ten (10) Days from the effective date of any change in: a. its certificate of incorporation or other organizational document; b. more than a controlling interest in the ownership of the Contractor; or c. the individual(s) in charge of the Performance. This change shall not relieve the Contractor of any responsibility for the accuracy and completeness of the Performance. DAS, after receiving written notice by the Contractor of any such change, may require such agreements, releases and other instruments evidencing, to DAS’s satisfaction, that any individuals retiring or otherwise separating from the Contractor have been compensated in full or that provision has been made for compensation in full, for all work performed under terms of the Contract. The Contractor shall deliver such documents to DAS in accordance with the terms of DAS’s written request. DAS may also require, and the Contractor shall deliver, a financial statement showing that solvency of the Contractor is maintained. The death of any Contractor Party, as applicable, shall not release the Contractor from the obligation to Perform under the Contract; the surviving Contractor Parties, as appropriate, must continue to Perform under the Contract until Performance is fully completed.

  • Project or Building Name and Signage Landlord shall have the right at any time to change the name of the Project or Building and to install, affix and maintain any and all signs on the exterior and on the interior of the Project or Building as Landlord may, in Landlord’s sole discretion, desire. Tenant shall not use the name of the Project or Building or use pictures or illustrations of the Project or Building in advertising or other publicity or for any purpose other than as the address of the business to be conducted by Tenant in the Premises, without the prior written consent of Landlord.

  • Structure of Agreement The Trust is entering into this Agreement solely on behalf of the Fund or Funds named herein individually and not jointly. Notwithstanding any to the contrary in this Agreement, no breach of any term of this Agreement shall create a right or obligation with respect to any series of the Trust other than the Fund; (b) under no circumstances shall the Adviser have the right to set off claims relating to the Fund by applying property of any other series of the Trust; and (c) the business and contractual relationships created by this Agreement, consideration for entering into this Agreement, and the consequences of such relationship and consideration relate solely to the Trust and the Fund.