SWITCHBACK STANDARDS Sample Clauses

SWITCHBACK STANDARDS. A switchback is defined as a curved segment of road between a beginning and end of the same curve, where the change of traffic travel direction is greater than 90 degrees. Purchaser shall follow these standards for switchbacks:  Maximum adverse grades for switchbacks is 10%.  Maximum favorable grades for switchbacks is 12%.  Maximum transition grades entering and leaving switchbacks is a 5% grade change.  Transition grades required to meet switchback grade limitations must be constructed on the tangents preceding and departing from the switchbacks.

Related to SWITCHBACK STANDARDS

  • OMB Standards Unless specified otherwise within this agreement, the Subrecipient shall procure all materials, property, or services in accordance with the requirements of 24 CFR 84.40−48.

  • Service Level Standards In addition to all other requirements in this Agreement, and in accordance with the Best Claims Practices & Estimating Guidelines, Vendor shall use reasonable and good faith efforts to meet the Service Level Standards set forth below.

  • Safety Standards Performance of the Contract for all commodities or contractual services must comply with requirements of the Occupational Safety and Health Act and other applicable State of Florida and federal requirements.

  • Service Standards 6.1 The Supplier shall provide the Services or procure that they are provided with reasonable skill and care, in accordance with Good Industry Practice prevailing from time to time and with Staff who are appropriately trained and qualified. 6.2 If the Services do not meet the Specification, the Supplier shall at its own expense re-schedule and carry out the Services in accordance with the Specification within such reasonable time as may be specified by the Authority. 6.3 The Authority may by written notice to the Supplier reject any of the Goods which fail to conform to the approved sample or fail to meet the Specification. Such notice shall be given within a reasonable time after delivery to the Authority of the Goods. If the Authority rejects any of the Goods it may (without prejudice to its other rights and remedies) either: (a) have the Goods promptly either repaired by the Supplier or replaced by the Supplier with Goods which conform in all respects with the approved sample or with the Specification and due delivery shall not be deemed to have taken place until the repair or replacement has occurred; or (b) treat the Contract as discharged by the Supplier’s breach and obtain a refund (if the Goods have already been paid for) from the Supplier in respect of the Goods concerned together with payment of any additional expenditure reasonably incurred by the Authority in obtaining replacements. 6.4 The Authority will be deemed to have accepted the Goods if it expressly states the same in writing or fails to reject the Goods in accordance with Clause 6.3. 6.5 If the Authority issues a receipt note for delivery of the Goods it shall not constitute any acknowledgement of the condition, quantity or nature of those Goods or the Authority's acceptance of them. 6.6 The Supplier hereby guarantees the Goods against faulty materials or workmanship for such period as may be specified in the Specification or, if no period is so specified, for 3 years from the date of acceptance. If the Authority shall within such guarantee period or within 30 Working Days thereafter give notice in writing to the Supplier of any defect in any of the Goods as may have arisen during such guarantee period under proper and normal use, the Supplier shall (without prejudice to any other rights and remedies which the Authority may have) promptly remedy such defects (whether by repair or replacement as the Authority shall choose) free of charge. 6.7 Any Goods rejected or returned by the Authority pursuant to this Clause 6 shall be returned to the Supplier at the Supplier’s risk and expense.

  • REFERENCE STANDARDS Reference to the standards of any technical society, organization, or association, or to codes of local or state authorities, shall mean the latest standard, code, specification, or tentative standard adopted and published as of the date of execution of the Construction Agreement, unless specifically stated otherwise.