The Contractor’s design Sample Clauses
The Contractor’s design. 4.1 At the end of clause 21.1 delete the full stop and add: “and in the provision of its design and carrying out of due diligence on the Part B Scope acts as a competent and experienced contractor and uses all the reasonable skill, care and diligence and the best up-to-date practice to be expected of a fully qualified and competent designer experienced in designing and performing and carrying out design for projects of a similar size, scope, nature, complexity and timescale to the works.”
4.2 Add new clause 21.4:
The Contractor’s design. X15.1 In line 2 delete "reasonable skill and care" and insert "the standard of care referred to in clause 21.4(b)" X15.2 Delete this clause and insert "Not used." Insert new OPTION X23: CIC BIM PROTOCOL (only applies when BIM is required)
The Contractor’s design. The Contractor shall carry out, and be responsible for the design and execution of part of the temporary traffic arrangements for the Project, as further detailed in the Volume 3 (Prerequisites and Introduction to engineering) ("the Contractor's Design"). The Contractor undertakes that the Contractor's Design, will be in accordance with the Law and the Contract.
The Contractor’s design. The Contractor will complete the Design documentation and submit it to the Employer for review, once accepted, the Contractor will Approve the Design (ECSA Registered) and the Employer will then authorize the Design. Only when the Design have been authorised by the Employer, may the Contractor start with implementation of the works. Where additional information is required, the Contractor collects all data for the design to enable the completion of the Works. The Contractor clarifies and co-ordinates all interfaces and displays.