Measurement System Clause Samples
The Measurement System clause defines the methods and standards by which work progress, quantities, or performance are measured and verified under a contract. Typically, it specifies the tools, units, and procedures to be used for measurement, such as requiring certified surveys, calibrated instruments, or adherence to industry standards. This clause ensures that all parties have a clear, agreed-upon process for quantifying deliverables, thereby reducing disputes and ensuring accurate payment or performance assessment.
Measurement System. Customer shall not alter, move, modify or otherwise change the measurement and verification system or any component thereof without the written consent of ConEdison Solutions unless such action is in accordance with operating procedures provided by ConEdison Solutions.
Measurement System. Fully automated data acquisition and test control system. Load, displacement, and temperature are simultaneously recorded every 0.1 sec.
Measurement System. Customer shall not alter, move, modify or otherwise change the measurement and verification system or any component thereof without the prior written consent of Ameresco unless such action is in accordance with operating procedures provided by Ameresco.
Measurement System. Analysis (MSA)
Measurement System. The measurement system shall be designed with sufficient redundancy (3x50 %) such that the failure of a single meter run does not shut down the whole measurement system. Each of these meter runs shall incorporate a single turbine meter and a single multipath ultrasonic meter in series in full compliance with above listed standards. Double block and bleed valves shall be provided upstream and downstream of each meter run to allow switching from one run to another without compromising measurement performance and to ensure no gas bypasses the intended meter runs.
Measurement System. 1 This section specifies the measurement rules that will generally be used for payment purposes unless otherwise specified in the Contract Documents. In case of conflict between the method of measurement specified in this section and the requirements specified in Section 01280 – Measurement Schedule, the latter will govern.
Measurement System. The Quality Manual will define the Measurement System to be used to obtain the data necessary to verify that DMOQs have been met, and to provide data needed to perform source cause and root cause analyses. Changes to the agreed upon Measurement System must be reviewed with and concurred by AT&T prior to their implementation. GTE will review metrics on a monthly basis with AT&T and will be available for review and analysis, as mutually agreed to be necessary, for all services. Measures shall be AT&T specific and support AT&T service performance requirements.
Measurement System. GR&R must be done for all the measurement systems and updated timely, the acceptable criterial follows industry standard (P/T Ratio<30%). Any deviation will be subjected to Cognex approval. Calibration must be done per national standard in timely manner.
Measurement System. Seller shall design, install, own, operate and maintain at Seller's expense, metering systems that are capable of measuring the quantity of hydrogen, steam and refinery fuel gas to be delivered hereunder and determining compliance with the specifications set forth herein, in accordance with the applicable industry standards referenced in this section. Such meters shall be connected to an electronic gas measurement ("EGM") system ("EGM System") as defined in the American Petroleum Institute's MPMS, Chapter 21, Section 1 - "Electronic Gas Measurement."
Measurement System. Set of equipment required for the measurement of electric grandeur, such as set of measurers, power transformers, current transformers and associated equipment, as required to measure active and reactive energy, active and reactive power, tension, etc., according to the Technical Specifications of the Measurement System for the invoicing of Electric Power of ONS/CCEE;