Project Substation Sample Clauses

Project Substation. Per the Interconnection Agreement.
View SourceView Similar (3)
Project Substation. The project substation will function to further increase the voltage to match the voltage of the BPA transmission system of 500kV. The project substation and associated interconnection infrastructure will include equipment such as free-standing steel switch-rack structures, one or more main power transformer(s)m breakers, power meters, and associated electrical lines.
View SourceView Similar (3)
Project Substation. The Project Substation will be an outdoor air insulated low profile design, single bus configuration located adjacent to the ▇▇▇▇▇▇▇ Substation, discussed below. It will consist of five 1250A grounding circuit breakers for the collector lines connected to the 34.5/230 kV step-up transformer. These breakers will be rated 38 kV maximum voltage 25 kA interrupting capability. A 34.5 kV disconnect switch will be installed on the 34.5 kV side of the main step-up transformer. The Project Substation circuit breakers, disconnect switches, PTs, CTs, and surge arresters will be connected by a combination of strain buses and rigid buses mounted on porcelain insulators, supported on steel structures. The Project Substation will include circuit breaker current transformers and bus- connected voltage transformers for metering and relaying. A 34.5 kV-120/240V station service transformer will supply power for the station service. All equipment, including fences, will be grounded to a sub-grade grounding system designed to IEEE 80 requirement. The substation area shall be covered with a 4 inch layer of # 2 crushed stone over a 6 inch layer of NYSDOT item 4 and will extend for a distance equal to 5 feet beyond the fence line.
View SourceView Similar (2)
Project Substation. EPC Contractor shall design, procure and install the Project Substation located on the Site, which will incorporate Owner’s Transformer. The Project Substation shall generally consist of all civil foundation, structures, circuit breakers, switches, metering and instrumentation, relays and controls, arresters, transformers, control buildings, SCADA, telecommunications and appurtenant facilities and equipment.
View Source
Project Substation. A high-voltage substation connected to each Station Unit beginning at the high-voltage terminals of such Station Unit’s step-up transformer.
View Source

Related to Project Substation

  • Project Site The “Project Site” is the place where the Work is being carried on.

  • Project 3.01. The Recipient declares its commitment to the objectives of the Project. To this end, the Recipient shall carry out the Project in accordance with the provisions of Article IV of the General Conditions.

  • Underground Facilities All underground pipelines, conduits, ducts, cables, wires, manholes, vaults, tanks, tunnels, or other such facilities or attachments, and any encasements containing such facilities, including without limitation those that convey electricity, gases, steam, liquid petroleum products, telephone or other communications, cable television, water, wastewater, storm water, other liquids or chemicals, or traffic or other control systems.

  • Generating Facility The Interconnection Customer’s device for the production of electricity identified in the Interconnection Request, but shall not include the Interconnection Customer’s Interconnection Facilities.

  • Access to Project Site ‌ City will make available, no later than the commencement date designated in the current construction Schedule accepted by City, the lands and facilities upon which the Work is to be performed, including such access and other lands and facilities designated in the Contract Documents, for use by Contractor.