STANDARD CONFIGURATION Sample Clauses

STANDARD CONFIGURATION. Contractors shall provide itemized pricing on all Products offered in the Standard Configurations. The Standard Configuration price and its component prices will remain equal to the Agreement awarded price for the term of the Agreement and any extensions, though Contractor may offer lower pricing at any time on an individual transaction.

STANDARD CONFIGURATION. Pricing for Products included in each Standard Configuration represents a discount off the Net NYS Contract Price from the Contractor's Manufacturer Umbrella Contract Price List. Contractor must provide itemized pricing on all Products offered in each Standard Configuration. In no event may quoted pricing exceed Net NYS Contract Price on the Contractor's Manufacturer’s Umbrella Contract Price List. The Price of the Standard Configuration and its component prices will remain equal to the Agreement awarded price for the term of the Agreement(s) and any extensions, though Contractor may offer lower pricing at any time.

STANDARD CONFIGURATION. If an asset must use a non-standardized configuration, approval of the use must be provided by August Schools management and such approval and request must be documented.

STANDARD CONFIGURATION. As to TENANT’s initial and subsequent installation of its Approved Equipment, and subject to availability and Tower structural capacity, LANDLORD shall at each Licensed Premises provide TENANT Tower Space and an Equipment Area to allow for and support the greater of TENANT’s existing Tower Space and Equipment Area entitlements as of the Amendment Effective Date, or TENANT’s “Standard Configuration”, which is defined as and shall consist of: (i) Any combination of Tower-mounted antennas and related electronic equipment, which may differ in type, quantity, weight and dimensions, but excluding mounts, provided that, (y) such equipment may not have a combined surface area that exceeds twenty thousand (20,000) square inches when determined by multiplying the two largest dimensions (length, width or depth) of such equipment, and (z) such equipment must be entirely contained within a ten foot (10’) vertical space or “envelope” on the subject Tower; (ii) An area for cables of any type, including, without limitation, coaxial, conduit and hybrid cables, with an aggregate outside line diameter of up to twenty-two (22) square inches of aggregate diameter cable space; (iii) The Equipment Area space equals a minimum of two hundred forty (240) contiguous square feet, within space leased or controlled by LANDLORD at the time TENANT submits an application provided that the Prime Lease allows for it; and (iv) Microwave antennas and related equipment (“MW Equipment”) will be deemed to be included within the Standard Configuration provided that they fit within the ten foot (10’) vertical envelope described above, within the same RAD center. (v) If a second RAD center on the Tower is necessary for the placement of MW Equipment or a second antenna array, and if space is available for such use, TENANT shall have the right to use the second RAD center and the Monthly Rent will increase in accordance with the following table. Extra square inch beyond Standard Configuration at Primary antenna array or Secondary antenna array $0.11 Line diameter over Standard Configuration - 0.25" incremental $15 Microwave addition outside of the Standard Configuration vertical space or “envelope” together with any applicable microwave ▇▇▇▇ and lines $100/ ft. in Microwave Diameter Secondary antenna array outside of the Standard Configuration vertical space or “envelope” (includes same entitlement rights as the Standard Configuration except for rights to additional ground space) $1,650 Additional gr...