Weather Limitations Clause Samples

Weather Limitations. The material shall be placed only when the surface is dry and the atmospheric and surface temperature is at least 45°F and rising and there is no chance of temperatures below 32°F within 24 hours from the time the material is applied.

Weather Limitations. Dust abatement Materials shall not be applied when it is raining. Bituminous Material shall be applied when the surface temperature of Traveled Way is 50 degrees Fahrenheit or higher. Lignin sulfonate and magnesium chloride shall be applied when the atmospheric temperature is 40 degrees Fahrenheit or higher.

Weather Limitations. 4 Do not place HMA for wearing course on any Traveled Way beginning October 1st 5 through March 31st of the following year without written concurrence from the Engineer. 6 7 Do not place HMA on any wet surface, or when the average surface temperatures are 8 less than those specified below, or when weather conditions otherwise prevent the 9 proper handling or finishing of the HMA. 10

Weather Limitations. Do not transport asphalt mix from the plant to the roadway unless all weather conditions are suitable for the paving operations.

Weather Limitations. Project activities shall be restricted to periods of low rainfall (i.e., less than 0.25 inch per 24-hour period), dry weather, and periods of no flow with no standing water. Permittee shall monitor the National Weather Service 72- hour forecast3 for the Project area’s precipitation (i.e., those with greater than a 25% chance of rain) and shall also consider potential increases in stream flow when planning activities in relation to the Project’s associated watershed. If there is a 25% or greater probability of rain totaling more than 0.25 inch within a 24-hour period predicted by the National Weather Service’s forecast, all Project activities shall cease within 24 hours of predicted rain, and protective measures to prevent sediment transport and/or erosion shall be implemented prior to the onset of rain. All protective measures to prevent sediment transport and/or erosion shall be maintained during the course of any storm that occurs during the course of Project activities. Project activities shall not recommence until after a dry-out period of 48 hours (i.e., less than 25% of rain for 48-consectutive-hours, for which any 24-hour period thereof holds less than 0.25 inches of rain) post-rain events occurs.

Weather Limitations. Place the overlay during favorable weather conditions. When the atmospheric temperature is expected to exceed 85 °F (29 °C) during daylight hours, schedule work hours that insure complete placement by 10:30 a.m. Do not schedule placement when wind velocity is expected to exceed 20 mph (32 km/hr) or when rain is expected. The minimum acceptable temperature of concrete at the point of delivery is 50 °F (10 °C). Keep overlay concrete at a temperature above 50 °F (10°C) for at least 72 hours after placement.

Weather Limitations. Proceed with reroofing preparation only when existing and forecasted weather conditions permit Work to proceed without water entering existing roofing system or building.

Weather Limitations. 5.1 The Services are to be continuous except in the event of inclement weather. The City reserves the right to suspend any or all work due to poor weather conditions. The City reserves the right to authorize the delayed work to be performed at a later date, or the City may deem it more appropriate to omit the delayed work and resume the normal schedule. The Contractor should not perform any suspended work without written authorization from the City. 5.2 While work is suspended due to inclement weather conditions, the Contractor should maintain readiness to resume work when conditions again become favorable enough to proceed.

Weather Limitations. Permittee's activities within the stream shall be restricted to periods of low rainfall (less than ¼ inch per 24-hour period) and periods of no or low stream flow and dry weather (with less than a 40 percent chance of rain). Precipitation forecasts and potential increases in stream flow shall be considered when planning maintenance activities. All erosion control measures shall be utilized to meet the Measures of this Agreement. Permittee shall monitor the National Weather Service (NWS) 72-hour forecast for the Project area. Weather forecasts shall be documented upon request by CDFW.