Completion of Plans and Specifications Sample Clauses

Completion of Plans and Specifications. All Plans and -------------------------------------- Specifications shall be prepared in strict compliance with applicable Building standards and requirements, this Work Letter and otherwise, and shall also adhere to the design drawings approved by Landlord. In order to assure the compatibility of Tenant's electrical and mechanical systems and the compatibility of Tenant's structural requirements with the existing Building and in order to expedite the preparation of Tenant's electrical, mechanical and structural drawings, Tenant or Tenant's Architect shall deliver to Landlord's Architect, not later than thirty (30) Working Days from the date of Landlord's approval of design drawings, a detailed plan setting forth any and all electrical, mechanical and structural requirements, and Landlord's Architect shall retain, at Tenant's expense, Landlord's electrical, mechanical and structural engineers to prepare all necessary electrical, mechanical and structural construction drawings which shall be included as a part of the Plans and Specifications. All construction documents and calculations prepared by Tenant's Architect shall be submitted by Tenant, in the form of four (4) sets of blueline prints, to Landlord for approval within ten (10) Working Days after the date of receipt by Tenant of Landlord's approval of design drawings. If the Plans and Specifications are returned to Tenant with comments, but not bearing approval of Landlord, the Plans and Specifications shall be immediately revised by Tenant and resubmitted to Landlord for approval within fifteen (15) Working Days of their receipt by Tenant. (i) The fees for Tenant's Architect and any consultants or engineers retained by or on behalf of Tenant or Tenant's Architect (including, but not limited to, the electrical, mechanical and structural engineers required to be retained under this paragraph) shall be paid by Tenant. Tenant shall also pay for any preliminary drawings by Landlord's Architect for review of the design drawings, the Plans and Specifications, and any revisions to such documents, and the fees and expenses of Landlord's Architect for inspection of the Work, as required by Landlord. Tenant may use funds from the Allowance to make such payments. (ii) Tenant shall have the sole responsibility for compliance of the Plans and Specifications with all applicable statutes, codes, ordinances and other regulations, and the approval of the Plans and Specifications or calculations included therein by Lan...
View SourceView Similar (13)
Completion of Plans and Specifications. All Plans and Specifications shall be prepared in strict compliance with applicable standards and requirements as set forth in the Lease, this Work Letter and otherwise, and shall also adhere to the design drawings approved by Lessor. Lessee shall deliver to Lessor, as soon as practicable after the date of Lessor's approval of design drawings, the proposed Plans and Specifications. If the Plans and Specifications are returned to Lessee with comments, but not bearing approval of Lessor, the Plans and Specifications shall be revised by Lessee and resubmitted to Lessor for approval. This process will continue until approval of Lessor is obtained.
View SourceView Similar (6)
Completion of Plans and Specifications. Based upon the approved Design Drawings, Landlord shall direct the architect selected by Landlord to prepare Plans and Specifications and submit the Plans and Specifications to Landlord and Tenant for approval in accordance with this Paragraph 2(b). Within five (5) business days after Tenant’s receipt of the Plans and Specifications, Tenant shall return to Landlord one (1) set of Plans and Specifications with Tenant’s requested modifications or approval. If Tenant returns the Plans and Specifications with comments, but not bearing approval of Tenant, the Plans and Specifications shall be revised by Landlord, to the extent Tenant’s proposed revisions are acceptable to Landlord, and resubmitted to Tenant for approval, following which the process under this Paragraph 2(b) shall continue until Tenant and Landlord have approved the Plans and Specifications.
View Source
Completion of Plans and Specifications. All Plans and Specifications shall be prepared
View Source
Completion of Plans and Specifications. All Plans and Specifications shall be prepared in strict compliance with applicable Building standards and requirements, this Work Letter and otherwise, and shall also adhere to the design drawings approved by Landlord. In order to assure the compatibility of Tenant's electrical and mechanical systems and the compatibility of Tenant's structural requirements with the existing Building and in order to expedite the preparation of Tenant's electrical, mechanical and structural drawings, Tenant or Tenant's Architect shall deliver to Landlord's Architect, not later than thirty (30) Working Days from the date of Landlord's approval of design drawings, a detailed plan setting forth any and all electrical, mechanical and structural requirements, and Landlord's Architect shall retain, at Tenant's expense, Landlord's electrical, mechanical and structural engineers to prepare all necessary electrical, mechanical and structural construction drawings which shall be included as a part of the Plans and Specifications. All construction documents and calculations prepared by Tenant's Architect shall be submitted by Tenant, in the form of four
View Source
Completion of Plans and Specifications. Notwithstanding the foregoing provisions of Articles 1, 2 and 3, Borrower and Lender recognize that the Plans and Specifications (Exhibit B), the Financial Requirement Analysis.(Exhibit D) and the Disbursement Plan (Exhibit E) have not been completed as of the date of this Agreement and will not be completed as of the Effective Date. Accordingly, Exhibits B, D and E attached to this Agreement are incomplete. Borrower shall, on or before November 1, 1991, (a) cause complete Plans and Specifications for the Improvements to be prepared, (b) prepare a final construction cost budget based on the complete Plans and Specifications, (c) enter into the Construction Agreement with the Contractor consistent with the complete Plans and Specifications and the final construction cost budget, and (d) obtain all required building permits for construction of the Improvements. The complete Plans and Specifications, the final construction cost budget, the Contractor and the Construction Agreement shall be subject to the prior written approval of Lender. Upon such approval by Lender, Borrower and Lender each shall execute and deliver an amendment to this Agreement containing Exhibits B, D and E, which shall become part of this Agreement, on the basis of the complete Plans and Specifications and the final construction cost budget approved by Lender. The total amount of the Loan shall not exceed three million dollars ($3,000,000), and Borrower shall pay all costs over three million dollars ($3,000,000) necessary to complete the Improvements in accordance with this Agreement.
View Source

Related to Completion of Plans and Specifications

  • Approval of Plans and Specifications The Plans and Specifications will conform to the requirements and conditions set out by applicable law or any effective restrictive covenant, and to all governmental authorities which exercise jurisdiction over the Leased Premises or the construction thereon.

  • Plans and Specifications After Landlord receives and approves Tenant’s Space Plan as provided above, Tenant will cause Tenant’s Architect to prepare the Plans and Specifications for the Tenant Improvements. Landlord will approve or disapprove (specifically describing any reasons for disapproval) the Plans and Specifications in writing within ten (10) Business Days after receiving them. If Landlord disapproves the Plans and Specifications, Tenant will provide appropriately revised Plans and Specifications to Landlord for approval (or disapproval) within five (5) Business Days on the same basis as set forth above. After Landlord’s approval, Tenant will submit the Plans and Specifications for permits and construction bids. No deviation from the Building Standard will be permitted in the Space Plan or the Plans and Specifications, provided reasonable deviations with respect to the ceiling, lighting, painting, flooring and wall covering may be permitted with Landlord’s approval. Landlord will not approve any deviations which Landlord believes (a) do not conform to applicable codes, ordinances and other Laws or are disapproved by any governmental agency, (b) require services beyond the level normally provided to other tenants in the Building, or (c) are of a nature or quality that are inconsistent with Landlord’s overall plan or objectives for the Building. No approval by Landlord of any deviation constitutes an acknowledgment by Landlord that such deviations are in conformance with applicable codes, ordinances and other Laws. In the event that Landlord’s approval shall be required in this Tenant Improvements Agreement, then notwithstanding anything to the contrary set forth in the Lease, Landlord’s approval shall not be unreasonably withheld, conditioned, or delayed.

  • Construction of the Tenant Improvements (a) Tenant shall construct and install the Tenant Improvements in a good and workmanlike manner, in compliance with all Laws and in accordance with this Exhibit B. Tenant’s proposed architect/engineer, general contractor, and fire protection, plumbing, HVAC and electrical subcontractors are subject to Landlord’s prior approval. Promptly following the selection and approval of the architect/engineer, Tenant shall forward to said architect/engineer (and copy Landlord on the transmittal) Landlord’s building standards heretofore delivered to Tenant, and Tenant shall cause said architect/engineer to comply with said building standards. Promptly following the selection and approval of the general contractor, Tenant shall forward to said general contractor (and copy Landlord on the transmittal) Landlord’s fire protection, plumbing, HVAC and electrical specifications and Landlord’s rules of conduct, all of which have been delivered to Tenant prior to the date of this Lease, and Tenant shall cause said general contractor to comply with said specifications and rules of conduct. At Landlord’s request, Tenant shall coordinate a meeting among Landlord (who will reasonably make its representative available for such meeting), Tenant and Tenant’s general contractor to discuss the Building systems and other matters related to the construction of the Tenant Improvements. (b) Promptly following the date hereof, Tenant shall prepare and submit to Landlord a set of permittable construction drawings (the “CDs”), based on the preliminary plans attached hereto as Exhibit B-2 and made a part hereof (the “Preliminary Plans”), covering all work to be performed by Tenant in constructing the Tenant Improvements. Tenant shall have no right to make any Tenant Improvements that would materially alter the exterior appearance of the Building or the Building systems without Landlord’s prior approval. Landlord shall have fifteen (15) days after receipt of the CDs in which to review the CDs and in which to give Tenant written notice of its approval of the CDs or its requested changes to the CDs in reasonably sufficient detail so as to allow Tenant to make the requested changes (provided that Landlord shall not be permitted to request a change that is inconsistent with the Preliminary Plans). If Landlord requests any changes to the CDs, Tenant shall make such changes and shall, within fifteen (15) days of its receipt of Landlord’s requested changes (if any), submit the revised portion of the CDs to Landlord. Landlord shall have five (5) business days after receipt of the revised CDs in which to review said revised CDs and in which to give to Tenant written notice of its approval of the revised CDs or its requested changes thereto. This process shall continue until such time, if at all, that Landlord approves the CDs in accordance with this Section 2. Tenant shall at all times in its preparation of the CDs, and of any revisions thereto, act reasonably and in good faith. Landlord shall at all times in its review of the CDs, and any revisions thereto, act reasonably and in good faith.

  • Construction of Tenant Improvements After the Landlord and Ground Lessor (in accordance with Paragraph 12 hereof) approve Tenant’s Plans and Tenant receives any necessary building permits, Tenant shall administer and diligently prosecute the construction of Tenant Improvements in accordance with Tenant’s Plans, in compliance with applicable Laws, and using building standard material, subject to Landlord’s right, at its election, to itself construct the Restroom Improvements. All Tenant Improvements (other than, if applicable, the Restroom Improvements) shall be constructed by Tenant’s Contractor (and/or its subcontractors), and Tenant shall be responsible for project management with respect to construction of the Tenant Improvements. During construction of the Tenant Improvements, Tenant and its contractors and subcontractors (i) shall not interfere with the access to, use of, or business conducted within any other portions of the Project by other tenants or occupants, (ii) shall use diligent efforts to coordinate the timing of work, deliveries and other construction matters with tenants or occupants of the Project that could be adversely impacted by such work, deliveries and construction matters, including, without limitation, by scheduling work that would create noise, vibrations, dust or other similar annoyances to other tenants or occupants of the Project outside normal business hours, notwithstanding any additional cost (for overtime or otherwise) that Tenant may incur, (iii) shall clean and secure construction and staging areas daily, (iv) shall stage all construction and store all construction materials and equipment in a location designated by Landlord (in Landlord’s sole discretion) on the Project, and (v) shall otherwise abide by all rules and requirements established or imposed by Landlord relating to the performance of the Tenant Improvements, including rules relating to any required shutdown of utilities (including life-safety systems), storage of materials, and coordination of work with other tenant’s or occupant’s contractors. Tenant shall not be charged any construction management fee for Landlord’s review of Tenant’s Plans or any oversight of the construction of the Tenant Improvements.

  • Drawings and Specifications 9.1 A complete list of all Drawings that form a part of the Contract Documents are to be found as an index on the Drawings themselves, and/or may be provided to Developer and/or in the Table of Contents. 9.2 Materials or Work described in words that so applied have a well-known technical or trade meaning shall be deemed to refer to recognized standards, unless noted otherwise. 9.3 Trade Name or Trade Term It is not the intention of the Contract Documents to go into detailed descriptions of any materials and/or methods commonly known to the trade under “trade name” or “trade term.” The mere mention or notation of “trade name” or “trade term” shall be considered a sufficient notice to Developer that it will be required to complete the work so named, complete, finished, and operable, with all its appurtenances, according to the best practices of the trade. 9.4 The naming of any material and/or equipment shall mean furnishing and installing of same, including all incidental and accessory items thereto and/or labor therefor, as per best practices of the trade(s) involved, unless specifically noted otherwise. 9.5 Contract Documents are complementary, and what is called for by one shall be binding as if called for by all. As such, Drawings and Specifications are intended to be fully cooperative and to agree. However, if Developer observes that Drawings and Specifications are in conflict with the Contract Documents, Developer shall promptly notify District and Architect in writing, and any necessary changes shall be made as provided in the Contract Documents. 9.6 Figured dimensions shall be followed in preference to scaled dimensions, and Developer shall make all additional measurements necessary for the work and shall be responsible for their accuracy. Before ordering any material or doing any work, each Developer shall verify all measurements at the building and shall be responsible for the correctness of same. 9.7 Should any question arise concerning the intent or meaning of the Contract Documents, including the Plans and Specifications, the question shall be submitted to the District for interpretation. If a conflict exists in the Contract Documents, these Construction Provisions shall control over the Facilities Lease, which shall control over the Site Lease, which shall control over Division 1 Documents, which shall control over Division 2 through Division 49 documents, which shall control over figured dimensions, which shall control over large-scale drawings, which shall control over small-scale drawings. In no case shall a document calling for lower quality and/or quantity of material or workmanship control. However, in the case of discrepancy or ambiguity solely between and among the Drawings and Specifications, the discrepancy or ambiguity shall be resolved in favor of the interpretation that will provide District with the functionally complete and operable Project described in the Drawings and Specifications. 9.8 Drawings and Specifications are intended to comply with all laws, ordinances, rules, and regulations of constituted authorities having jurisdiction, and where referred to in the Contract Documents, the laws, ordinances, rules, and regulations shall be considered as a part of the Contract Documents within the limits specified. 9.9 As required by Section 4-317(c), Part 1, Title 24, CCR: “Should any existing conditions such as deterioration or non-complying construction be discovered which is not covered by the DSA-approved documents wherein the finished work will not comply with Title 24, California Code of Regulations, a construction change document, or a separate set of plans and specifications, detailing and specifying the required repair work shall be submitted to and approved by DSA before proceeding with the repair work.”