Automatic Transfer Switch Clause Samples

Automatic Transfer Switch. 3.6.1. The automatic transfer switch shall be sized to the maximum capacity of the emergency generator and have an ampere rating equal or greater than the rating of the engine mounted circuit breaker. 3.6.2. Transfer switch shall be complete with a user friendly control interface with a 128 x 63 graphical LCD display and intuitive symbols for ease of operation 3.6.3. Transfer switch shall be complete with LED indicators for transfer switch status. 3.6.4. Transfer switch shall be UL 1008, and CSA approved. 3.6.5. Transfer switch shall be 2 pole with solid neutral 3.6.6. Transfer switch shall be supplied with “in-phase” monitor, and “engine exerciser”. 3.6.7. Standard of Acceptance: ASCO, Series 300 complete with Accessories #11BE, and #22 and #27. 4. Execution
View SourceView Similar (4)
Automatic Transfer Switch. 1. Install transfer switch in accordance with manufacturer's instructions. 2. Provide engraved plastic nameplates. 3. Provide generator start/stop signal wiring and conduit from transfer switch to generator control panel. 4. Provide interconnection wiring with duplex pump control circuit to allow only one pump to run while on generator power. 5. Provide 120 volt power source for heater.
View SourceView Similar (3)
Automatic Transfer Switch. This section shall contain detailed information that defines particular Field Tests to be performed to verify that the Automatic Transfer Switch meets the requirements of the RFP.
View Source
Automatic Transfer Switch. Inspect ATS & enclosure for corrosion, moisture • Inspect controls and calibrate as needed • Exercise clock-check and verify operation • Record normal and emergency frequency/voltage at ATS connection • Perform power failure or building load test (with approval), check/ record amperage/voltage on each leg • Check transfer switch contacts for voltage drop(normal and emergency) • Retrun all switches into proper operating mode • Check all terminal connections for tightness • Re-torque connections, TS mounting, contact mounting and terminals strips • Inspect all insulation for degradation • Inspect barries and arc chutes • Inspect Transfer Switch coil, rectifier and resistors (OHMS) • Inspect the coil and contacts of: o Selector relay o Lockout relay o Arming relay o Voltage relay o Normal relay o Emergency relay o All other accessory relays • Inspect all timers • Inspect and infared arcing contacts where possible • Inspect and infared main contacts where possible • Inspect linkage and lubricate as needed • Clean the exposed Transfer Switch coil core and lubricate • Clean Transfer Switch enclosure and controls • Inspect and lubricate cabinet hardware for proper operation • Re-lubricate the Transfer Switch operator and pivot points • Replace defective indicator bulbs • Record utility voltage • Record utility amperage • Record peak amperage • Check for proper operation of the transfer switch, timers, relays, remote start contacts, exercisers, phase monitors, and record settings • Check for voltage drop across the main current carrying contacts • Check for excessive heat build-up with infared thermometer • Record emergency voltage • Record emergency frequency • Inspect all optional accessories • Inspect arcing contacts • Inspect main contacts • Inspect barrier and arc chutes • Inspect linkage and lubricate as needed • Check engine start bypass contacts for proper operation • Inspect all safety interlocks • Check closed transition bypass operation • Check alarm time delay settings • Replace 9V ATS batteries as needed • Submit inspection/ test report to owner, with any recommendations of future work/ parts required • Instruct owner personnel in operating or upkeep procedure Generac SG050 2109620 50kW Behind Building $740.00 Total $740.00 This agreement does not include expenses to repair damage caused by abuse, accident, theft, acts of a third person, forces of nature, or altering the equipment. EVAPAR, shall not be responsible for failure to render the service for...
View Source
Automatic Transfer Switch. A. Supply new automatic delayed transition transfer switch (ATS) and associated microprocessor-based control module. B. Switch Ratings: As indicated on the Drawings. C. Provide one (1) spare microprocessor controller (in addition to new microprocessor controller provided installed with new automatic transfer switch). D. Provide one (1) spare extension harnesses for ATS provided. Spare harness shall be in addition to new harness installed in new automatic transfer switch provided. E. New ATS shall consist of a power transfer switch unit which shall be provided in an outdoor, NEMA 3R, 316 stainless steel free-standing enclosure. Standby Power System Equipment – Corporation Yard Foster City/EMID 16233A-35 CIP 405-755 F. Provide new ATS enclosure and compartment with Fluke Model FLK-075-CLKT (no equal) “fisheye” viewports to allow for infrared scanning of the internal ATS components with the enclosure door in the closed position.
View Source

Related to Automatic Transfer Switch

  • Transfer, Split Up Combination and Exchange of Rights ------------------------------------------------------ Certificates; Mutilated, Destroyed, Lost or Stolen Rights Certificates. ---------------------------------------------------------------------- (a) Subject to the provisions of Sections 7(e), 14 and 24 hereof, at any time after the Close of Business on the Distribution Date, and at or prior to the Close of Business on the Expiration Date, any Rights Certificate or Rights Certificates may be transferred, split up, combined or exchanged for another Rights Certificate or Rights Certificates, entitling the registered holder to purchase a like number of one-thousandths of a Preferred Share (or, following a Triggering Event, other securities, cash or other assets, as the case may be) as the Rights Certificate or Rights Certificates surrendered then entitled such holder to purchase. Any registered holder desiring to transfer, split up, combine or exchange any Rights Certificate or Rights Certificates shall make such request in writing delivered to the Rights Agent, and shall surrender the Rights Certificate or Rights Certificates to be transferred, split up, combined or exchanged at the office of the Rights Agent designated for such purpose. Neither the Rights Agent nor the Company shall be obligated to take any action whatsoever with respect to the transfer of any such surrendered Rights Certificate until the registered holder shall have completed and signed the certificate contained in the form of assignment on the reverse side of such Rights Certificate and shall have provided such additional evidence of the identity of the Beneficial Owner (or former Beneficial Owner) or Affiliates or Associates thereof as the Company shall reasonably request. Thereupon the Rights Agent shall, subject to Sections 7(e), 14 and 24 hereof, countersign and deliver to the person entitled thereto a Rights Certificate or Rights Certificates, as the case may be, as so requested. The Company may require payment of a sum sufficient to cover any tax or governmental charge that may be imposed in connection with any transfer, split up, combination or exchange of Rights Certificates. (b) Upon receipt by the Company and the Rights Agent of evidence reasonably satisfactory to them of the loss, theft, destruction or mutilation of a Rights Certificate, and, in case of loss, theft or destruction, of indemnity or security reasonably satisfactory to them, and, at the Company's request, reimbursement to the Company and the Rights Agent of all reasonable expenses incidental thereto, and upon surrender to the Rights Agent and cancellation of the Rights Certificate if mutilated, the Company will make and deliver a new Rights Certificate of like tenor to the Rights Agent for delivery to the registered holder in lieu of the Rights Certificate so lost, stolen, destroyed or mutilated.

  • Automatic Termination Unless earlier terminated pursuant to this Section 13, this Agreement shall automatically terminate upon the issuance and sale of all of the Placement Securities through (1) the Sales Agent on the terms and subject to the conditions set forth herein with an aggregate sale price equal to the amount set forth in Section 1 of this Agreement or (2) the Alternative Sales Agents through the Alternative Distribution Agreements on the terms and subject to the conditions set forth therein or any Placement Notice.

  • Automatic Conversion Subject to Section 5 below and, at the Company’s election and request, Holder’s reaffirmation of Holder’s representations and warranties under Section 3 of the Convertible Note Purchase Agreement, the principal amount of this Note (and all interest accrued on this Note at the option of the Payor) shall be converted into the number of shares of common stock as follows: (a) In the event of a next equity financing by the Company in one transaction or series of related transactions which raises an aggregate amount of at least One Million Five Hundred Thousand Dollars ($1,500,000) (the “Next Equity Financing”), the principal amount on this Note shall automatically be converted (regardless of whether or not the Note is surrendered to Payor) into the equity securities issued in the Payor’s Next Equity Financing (the “Next Equity Financing Stock”). Any accrued interest outstanding at the time of the conversion shall be paid in cash by the Company. This Note shall convert into the number of shares at the time of the “Next Equity Financing” equals to ___,000 shares of the Company’s Common Stock at an exercise price of $0.60 per share (the “Exercise Price”) This Note shall be deemed automatically cancelled immediately upon such conversion. As a condition precedent to the issuance of the Next Equity Financing Stock to Holder upon such conversion, Holder shall execute and deliver such agreements, instruments and other documents as are executed and delivered by the other investors in connection with their purchase of the Next Equity Financing Stock. (b) In the event of the “Company’s Sale”, defined below, at the option of Payor, the principal hereunder and, at the option of the Payor, shall automatically be converted (regardless of whether or not the Note is surrendered to Payor) into the number of shares (the “Company’s Sale Stock”) equals to ____,000 shares of the Company’s Common Stock at an exercise price of $0.60 per share (the “Exercise Price”). This Note shall be deemed automatically cancelled immediately upon such conversion.

  • Automatic Renewal Limitation for TIPS Sales No TIPS Sale may incorporate an automatic renewal clause that exceeds month to month terms with which the TIPS Member must comply. All renewal terms incorporated into a TIPS Sale Supplemental Agreement shall only be valid and enforceable when Vendor received written confirmation of acceptance of the renewal term from the TIPS Member for the specific renewal term. The purpose of this clause is to avoid a TIPS Member inadvertently renewing an Agreement during a period in which the governing body of the TIPS Member has not properly appropriated and budgeted the funds to satisfy the Agreement renewal. Any TIPS Sale Supplemental Agreement containing an “Automatic Renewal” clause that conflicts with these terms is rendered void and unenforceable.

  • Automatic Renewal Each Schedule will renew automatically at the end of the then-current Schedule Term for a Schedule Renewal Term unless terminated in accordance with this Agreement by either You or Company.