Technical Details Sample Clauses
The 'Technical Details' clause defines the specific technical requirements, standards, or specifications that must be met under the agreement. It typically outlines aspects such as hardware or software configurations, performance benchmarks, compatibility requirements, or data formats relevant to the subject matter. By clearly setting out these technical parameters, the clause ensures both parties have a mutual understanding of the technical expectations, reducing the risk of disputes or misunderstandings regarding deliverables.
POPULAR SAMPLE Copied 1 times
Technical Details as para 1 above
Technical Details. The type and construction of junction boxes shall be subject to the Employer's approval. Mounting plate Number of terminals is dependent on cable configuration. Terminals are on DIN rail with end stops and end plates. All terminals must be numbered top and bottom from left to right. Screen bar Separate removable gland plate on the bottom. Glands Cable trunking at the bottom and the top and at least one side. Any additional equipment to make a complete assembly. Powder coated 3CR12 stainless steel. IP65 degree of protection All cables shall be glanded with suitable compression glands, as far as possible to the back of the gland plate, without affecting the IP65 rating. Provision of spare cores for future expansion shall be made, 25% of the installed base. The Contractor shall familiarise himself with the plant areas and environmental conditions and provide alternative solutions where environmental conditions require higher protection. The Contractor shall label junction boxes in accordance with Employer’s system.
Technical Details. When submitting its tender, the Tenderer shall include all of the necessary documents describing the technical performance of its contract, the applicable methods and systems and the resources to be used, in so far as these have not been specified in the Technical Provisions.
Technical Details. The technical details of the visit to our site (domain analysis) are registered by us. We use this data for statistical purposes.
Technical Details. Technical details for the Pseudo-Tie are outlined in Appendix 1 to this Agreement. The Company shall maintain the Facility and its operations consistent with the specifications in Appendix 1 for the duration of the Agreement. Failure to maintain and operate the Facility consistent with the specifications outlined in Appendix 1 will be cause for suspension of the Agreement pursuant to section 11 below.
Technical Details. 9.1 EEX AG reserves the right to utilize any of the available connectivity channels and file formats specified by the competent authority.
9.2 EEX AG will provide the Draft Reports and only accepts Participant Reports in accordance with the relevant validations, technical specifications and formats applied by the so-called FIA/EFET schema. EEX AG will not adapt non-conforming messages to format requirements and will not accept those.
9.3 The technical and procedural details are stipulated in the MiFID II/MiFIR Reporting Description (“Description”), which shall apply – as amended from time to time – to this Agreement. The Description is available here.
Technical Details. 8.1 EEX AG reserves the right to utilize any of the available connectivity channels and file formats specified by the competent authorities.
Technical Details. Maximum Export Capacity
Technical Details. All the reports, data, comments and additional information from the partners should be sent to the WP3 leader in English and in Word (.docx) format, unless otherwise stated.
Technical Details. Nissan and Company agree as follows: