Correction of the Work Sample Clauses
The Correction of the Work clause establishes the contractor's obligation to fix any defects or deficiencies in the completed work identified by the owner or during inspections. Typically, this clause outlines a specific period during which the contractor must address and remedy any issues at their own expense, often after substantial or final completion. Its core practical function is to ensure the quality and integrity of the finished project by holding the contractor accountable for correcting mistakes, thereby protecting the owner's investment and maintaining project standards.
POPULAR SAMPLE Copied 2 times
Correction of the Work. Within the space of time designated in Notices of Non-Compliant Work and without expense to the Owner, the Contractor shall correct, remedy, replace, re-execute, supply omitted work, or remove from the premises all work designated as non-compliant by the Design Professional. The Contractor shall give prompt notice in writing to the Design Professional, with copy to the Owner, upon completion of the supplying of any omitted work or the correction of any work designated as non-compliant by the Design Professional. In the absence of said notice, it shall be and is presumed under this Contract that there has been no correction of the non-compliant work or supplying of omitted work. If the Contractor does not remove, make good the deficiency, correct, or remedy faulty work, or supply any omitted work within the space of time designated in Notices of Non-Compliant Work, then the Owner, after ten days' notice in writing to the Contractor, may remove the work, correct the work, remedy the work or supply omitted work at the expense of the Contractor. In case of emergency involving health, safety of property, or safety of life the Owner may proceed at once with correction of the Work without waiving any rights of the Owner. Correction of defective work executed under the plans and specifications or supplying of omitted work whether or not covered by warranty of a subcontractor or supplier, remains the primary, direct responsibility of the Contractor. The foregoing obligation of the Contractor shall remain in effect until the expiration of the statute of limitations covering the Work.
Correction of the Work. 4.9.1 The Agency shall have the right and authority to reject Work that does not conform to the Contract Documents. The Contractor shall promptly correct Work rejected by the Agency for failing to conform to the requirements of the Contract Documents, whether or not fabricated, installed or completed. The provisions of this Section apply to Work done by subcontractors as well as to Work done by direct employees of the Contractor.
4.9.2 If the Contractor fails to correct the Work, or any portion thereof, that is not in accordance with the requirements of the Contract Documents or fails to carry out Work or provide information in accordance with the Contract Documents, the Agency may make written demand upon the Contractor to cure its defaults within seven days. Within seven days after receipt of the Agency’s demand, the Contractor shall cure its defaults unless the default is such that it is not capable of cure within seven days. If the default is such that it is not capable of cure within seven days, the Contractor shall reach an agreement with the Agency on a plan to cure its defaults within five days after receipt of the Agency’s demand. The Contractor shall commence and diligently and continuously pursue the cure of such defaults in accordance with the agreed plan. If the Contractor fails to cure its defaults as heretofore provided, the Agency may order the Contractor, in writing, to stop the Work, or any portion thereof, until the Contractor has eliminated the cause for such order or has provided the Agency with a plan for corrective action acceptable to the Agency. The right of the Agency to stop the Work shall not give rise to a duty on the part of the Agency to exercise this right for the benefit of the Contractor or any other person or entity.
Correction of the Work. The Design-Builder shall within the space of time designated in Notices of Non-complying Work and without expense to the Owner, correct, remedy, replace, re-execute, supply omitted work, or remove from the premises all work designated as Non-complying by the Program Manager. The Design-Builder shall give prompt notice in writing to the Program Manager, with copy to the Owner, upon completion of the supplying of any omitted work or the correction of any work designated as Non-complying by the Program Manager. In the absence of said notice, it shall be and is presumed under this Contract that there has been no correction of the Non-complying work or supplying of omitted work. If the Design-Builder does not remove, make good the deficiency, correct, or remedy faulty work, or supply any omitted work within the space of time designated in Notices of Non-complying Work without expense to the Owner, the Owner, after ten (10) days' notice in writing to the Design-Builder, may remove the work, correct the work, remedy the work or supply omitted work at the expense of the Design-Builder. In case of emergency involving health, safety of property, or safety of life the Owner may proceed at once with correction of the Work without waiving any rights of the Owner. Correction of defective work executed under the plans and specifications or supplying of omitted work whether or not covered by warranty of a subcontractor or materialmen, remains the primary, direct responsibility of the Design-Builder. The foregoing obligation of the Design-Builder shall remain in effect until the expiration of the statute of limitations covering the Work.
Correction of the Work. If TxDOT determines that any of the Work has not met the standards set forth in this Section 11.1 at any time within the applicable Warranty Term, then DB Contractor shall correct such Work as specified in this Section 11, even if the performance of such corrective Work extends beyond the applicable Warranty Term.
Correction of the Work. In addition to the Contractor’s obligations under Section 12, if, within one year after the date of Final Completion of the Work or designated portion thereof or after the date for commencement of warranties established under Section 12, or by terms of an applicable special warranty required by the Contract Documents, any of the Work is found to be not in accordance with the requirements of the Contract Documents, the Contractor shall correct it promptly after receipt of notice from the Park District to do so unless the Park District has previously given the Contractor a written acceptance of such condition. The Park District shall give such notice promptly after discovery of the condition. The obligation under this Section 13 shall survive acceptance of the Work under the Contract Documents and termination of the Agreement. Corrective Work shall be warranted to be free from defects for a period equal to the longer of twelve (12) months after the completion of the corrective Work or one (1) year from the date of Final Completion of the Work, or such longer period of time as may be prescribed by law or in equity or by the terms of any applicable special warranty. Notwithstanding the foregoing, Contractor shall correct Work deficiently or defectively performed and replace defective or non- conforming materials and equipment, even though such deficiency, defect or non-conformity may be discovered more than one (1) year after Final Completion, if the correction is of a latent defect and arises from poor workmanship or improper materials or equipment, or is required to be made to Work, materials or equipment covered by the Contractor or a subcontractor contrary to the Park District’s request or to the request of a governmental officer, or to the requirements of the Contract Documents or governmental requirements, and was therefore not visible for inspection by the Park District or governmental officer, as applicable, at the time of inspection. Contractor shall, within a reasonable time under the circumstances, after receipt of written notice thereof, correct, repair, replace and otherwise make good any defects or non-conformity in the Work. If the Contractor fails to correct nonconforming Work within a reasonable time, the Park District may correct it in accordance with Section 10.
Correction of the Work. The Parties agree that the Project Manager shall have the right and authority to reject in writing, stating the reasons therefore, Work which does not conform with the Contract Documents. The ESCO shall promptly correct any Work rejected by the School District for failing to conform with the Contract Documents, whether observed before or after final acceptance by the School District and whether or not the Selected ECM is fabricated, installed, or completed, and shall make such corrections in accordance with Article 8 (Warranties). These provisions apply to Work done by Subcontractors as well as to Work done by direct employees of the ESCO.
Correction of the Work. Subcontractor shall immediately perform and pay for the correction of any of its work found to be defective or otherwise not in conformance with the Subcontract Documents.
Correction of the Work. A. Repair or remove and replace defective construction. Restore damaged substrates and finishes. Comply with requirements in Division 1 Section "Cutting and Patching."
1. Repairing includes replacing defective parts, refinishing damaged surfaces, touching up with matching materials, and properly adjusting operating equipment.
B. Restore permanent facilities used during construction to their specified condition.
C. Remove and replace damaged surfaces that are exposed to view if surfaces cannot be repaired without visible evidence of repair.
D. Repair components that do not operate properly. Remove and replace operating components that cannot be repaired.
E. Remove and replace chipped, scratched, and broken glass or reflective surfaces. END OF SECTION 01 73 00.
Correction of the Work. The Customer shall have the right and authority to reject Work which does not conform to the Contract Documents. The ESCO shall promptly correct Work rejected by the Customer for failing to conform to the requirements of the Contract Documents, whether observed before or after Substantial Completion and whether or not fabricated, installed or completed, and shall correct any Work found to be not in accordance with the requirements of the Contract Documents within the warranty period set forth in Section 5.10. The provisions of this Section 4.11 apply to Work done by Subcontractors as well as to Work done by direct employees of the ESCO.
4.11.1 If the ESCO fails to correct the Work, or any portion thereof, that is not in accordance with the requirements of the Contract Documents or fails to carry out Work or provide information in accordance with the Contract Documents, and the ESCO, after receipt of written notice from the Customer, either (i) has not cured such failure within seven (7) days or (ii) if the nature of the failure is such that it is not capable of cure within seven (7) days, has not reached agreement with the Customer for a plan to cure such failure or has not commenced and diligently and continuously pursued the cure of such failure in accordance with such plan within such seven (7) day period, then the Customer, by written order signed by the Customer or by an agent specifically so empowered by the Customer in writing, may order the ESCO to stop the Work, or any portion thereof, until the cause for such order has been eliminated or the ESCO has provided the Customer with a plan for corrective action acceptable to the Customer in its reasonable judgment. The right of the Customer to stop the Work shall not, however, give rise to a duty on the part of the Customer to exercise this right for the benefit of the ESCO or any other person or entity.
4.11.2 Nothing contained in this Section 4.11 shall be construed to establish a period of limitation with respect to other obligations which the ESCO might have under the Contract Documents. Establishment of such time period as described in this Section 4.11 relates only to the specific obligation of the ESCO to correct the Work, and has no relationship to the time within which the obligation to comply with the Contract Documents may be sought to be enforced, nor to the time within which proceedings may be commenced to establish the ESCO's liability with respect to the ESCO's obligations other than spe...
Correction of the Work. 12.2.1 ▇▇▇▇ shall promptly correct or remove work rejected by Director or work failing to conform to requirements of the Contract, whether observed before or after Date of Substantial Completion and whether fabricated, Installed, or completed.