WARRANTY TERMS AND CONDITIONS Clause Samples

WARRANTY TERMS AND CONDITIONS. The following terms and conditions (the “Warranty Terms and Conditions”) apply to the warranty made by Milliken & Company (“Milliken”) for Milliken Mosaic 98-Spray Adhesive for use with modular carpet and/or 5.0mm LVT, or 2.5mm LVT. These Warranty Terms and Conditions and related warranty do not apply to non-commercial installations. The warranty provided herein is in lieu of any and all other warranties, express or implied, including but not limited to implied warranties of merchantability and fitness for a particular purpose. This warranty is subject to the limitations and exclusions set forth in these Warranty Terms and Conditions and in the individual warranty. The warranty only applies when bond testing, substrate preparation, adhesive application and installation have all been performed in accordance with the requirements and instructions set forth on the product label, the product specification sheet, ▇▇▇▇▇▇▇▇’▇ then current published instructions for installation of modular carpet (which are specific for each carpet product), Change Agent and/or Loose Lay 5.0mm LVT, or 2.5mm LVT (as applicable), and the then current Carpet and Rug Institute publication CRI 104 (as applicable)(collectively, the “Documentation”). Furthermore, the installation must be in an indoor commercial environment. The warranty shall not apply (i) to installations on substrates that were not prepared as instructed in the Documentation; (ii) to substrates that are not free of silicate penetrating curing compounds and other topical or integral treatments that violate ASTM F710; (iii) to installations over substrates where hydrostatic pressure exists; (iv) where the claimant does not have written and photographic documentation of the bond testing conducted prior to the installation; (v) to installation failures due to outside sources of water; (vi) to installations taken up or replaced prior to inspection by authorized Milliken personnel; (vii) to installations with chemically cleaned substrates, where improper cleaning methods have been used, or where adhesive removers have been applied; (viii) to installations using incompatible curing compounds, mold release agents, or non-Portland cement based leveling or patch compounds; (ix) to failure of leveling or patch compounds of any kind; (x) to damage caused by expansion joints or other structural areas; (xi) to structural failure, seismic action, discoloration, caustic solutions entering the system topically through joints; or (xii) ...

WARRANTY TERMS AND CONDITIONS. PROBE CORPORATION undertakes, in its sole discretion to repair the defect, or replace the Battery at its own cost and without charge to the purchaser of the Battery, subject to the following conditions:-

WARRANTY TERMS AND CONDITIONS. 1.1 The Seller guarantees sold goods against any manufacturing defects for twelve months from the purchasing date. This warranty only covers hardware product components and only applies to hardware products manufactured by or on behalf of the Seller and that can be identified through the mark, the trade name or the “Gilbarco” logo on them, or anyway equipped with the relevant sale invoice. The software (by the Seller or by third parties) is subject to licence contracts with the final user or to distinct warranty conditions.‌ 1.2 Should any manufacturing defects be detected within the warranty period, the Seller or one of its authorised service shops shall repair/replace defective goods within the terms and under the conditions stated below, without any charge to the Buyer for the labour costs incurred to repair and/or replace the goods. 1.3 Replacement under warranty conditions shall only be performed if the defect is notified to the Seller within the warranty period. Procedures to request interventions under warranty conditions are subject to the following rules. In the event of an obvious defectiveness or incompleteness of the service or the supply, we are to be notified thereof in writing without delay, but at the latest within 8 days after receipt of the supply or service, and in the event of hidden deficiencies without delay but at the latest within two weeks after detection of the defect, including a precise description of the defect. At our request the defective goods are to be returned to us. Claims of the Customer on account of defectiveness or incompleteness of the delivery or service are excluded if it fails to comply with this obligation. Apart from that, German law sec. 377 HGB shall apply. Before requesting an intervention under warranty conditions the Seller encourages the user to thoroughly read the relevant operating instructions. This warranty shall not be applicable if the model indication or the serial number on the product have been modified, deleted, removed or made unreadable.

WARRANTY TERMS AND CONDITIONS. This Warranty shall be voided if the Product (i) has been subjected to abuse, misuse, neglect, negligence, accident, improper testing, improper installation, improper cleaning (such as use of abrasive cleaners), improper storage, improper handling, abnormal physical stress, abnormal environmental conditions, or use or installation contrary to any instructions or guidelines issued by Seller; (ii) has been altered, repaired, or reconstructed by anyone other than Seller; (iii) was installed by anyone other than a fully insured and licensed professional; (iv) was not installed according to Glass Warehouse’s published installation instructions or guidelines; (v) is installed or used outside of the US or Canada; or (vi) has been used with any third-party hardware or product that has not been previously approved in writing by Seller. This Warranty shall not apply to normal wear and tear. With respect to Products advertised by Glass Warehouse for outdoor use, this Warranty specifically excludes damage caused by extreme weather events. Neither Buyer, nor any other person is permitted to make any affirmation, representation, or warranty other than those contained in this Warranty. Any affirmation, representation, or warranty other than those contained in this Warranty shall not be enforceable against Seller or any other person. Seller reserves the right to modify this Warranty at any time, it being understood that such modifications will not alter the terms and conditions applicable at the time of sale of the products in question. Please register your information to activate your warranty. All Warranty claims are subject to review and confirmation by Seller, and Seller reserves the right to inspect the installation to confirm the validity of the Warranty claim. To submit a Warranty claim, Buyer must:

WARRANTY TERMS AND CONDITIONS. The following terms and conditions (the “Warranty Terms and Conditions”) apply to the warranty made by Milliken & Company (“Milliken”) for Milliken Moisture Extreme Spray Adhesive for use with modular carpet. These Warranty Terms and Conditions and related warranty do not apply to non-commercial installations. The warranty provided herein is in lieu of any and all other warranties, express or implied, including but not limited to implied warranties of merchantability and fitness for a particular purpose. This warranty is subject to the limitations and exclusions set forth in these Warranty Terms and Conditions and in the individual warranty. The warranty only applies to use of the Milliken Moisture Extreme Aerosol Adhesive product in carpet installations when bond testing, substrate preparation, adhesive application and carpet installation have all been performed in accordance with the requirements and instructions set forth on the product label, the product specification sheet, ▇▇▇▇▇▇▇▇’▇ then current published instructions for installation of modular carpet (which are specific for each carpet product), and the then current Carpet and Rug Institute publication CRI 104 (collectively, the “Documentation”). Furthermore, the carpet installation must be in an indoor commercial environment. The warranty shall not apply (i) to installations on substrates that were not prepared as instructed in the Documentation; (ii) to substrates that are not free of silicate penetrating curing compounds and other topical or integral treatments that violate ASTM F710;

WARRANTY TERMS AND CONDITIONS. This warranty is void if the product or the lighting system with which the product is operated is not installed, operated, or maintained in accordance with:

WARRANTY TERMS AND CONDITIONS. 8.1 The Seller guarantees the sold goods against any manufacturing defects at the purchasing date. Seller guarantees its Products will be free from manufacturing defects during the Warranty Period. The definitions of the product and its specific Warranty Terms and Conditions shall be governed by the terms of Annex 1 of these General Sale Conditions 8.2 This warranty is exclusive and supersedes any other quality and performance warranties, whether written, verbal or implicit. Any other warranties, including any implied warranties of merchantability or fitness for purpose, are hereby specifically excluded by GVR to the extent legally possible.

WARRANTY TERMS AND CONDITIONS. 1.1 This Warranty is provided by Gilbarco ▇▇▇▇▇▇-▇▇▇▇ (hereinafter "GVR" or "Seller") and shall apply between GVR and a customer who has purchased a Product directly from GVR or from an authorized GVR sales partner. 1.2 This Warranty is limited to these terms and conditions. In addition, the products supplied are guaranteed to be compliant to the GVR specifications. In the event a authorized GVR sales partner provides a warranty that is more extensive that this Warranty, GVR shall not, under any circumstances, be liable for any rights, obligations, actions or omissions that are more extensive than provided under this Warranty or any features, defects, errors or failures not covered by this Warranty. 1.3 GVR warrants that its Products are free from defects in materials and workmanship under normal use for the Warranty period. GVR warrants that the products sold are compliant with the Laws, the Certifications and the Regulations of the countries where the product will be sell.

WARRANTY TERMS AND CONDITIONS. THE OBLIGATIONS OF WOODLINE SHADE SOLUTIONS HEREUNDER ARE LIMITED TO REPAIR OR REPLACEMENT OF PARTS OF THE PRODUCT FOUND TO BE DEFECTIVE UNDER THIS LIMITED WARRANTY. IN NO EVENT SHALL WOODLINE SHADE SOLUTIONS BE LIABLE FOR ANY INDIRECT, INCIDENTAL OR CONSEQUENTIAL DAMAGES, INCLUDING BUT NOT LIMITED TO TIME, WAGES OR LOST PROFITS, OF ANY NATURE OR KIND OR FOR DAMAGES TO OR LOSS OF PROPERTY. In addition, Woodline Shade Solutions reserves the right to modify, refine, or improve its products and parts including making substitutions, without incurring any responsibility to modify, exchange, replace or repair any parts or products to meet prior specifications.