Scope Requirements Sample Clauses

The Scope Requirements clause defines the specific boundaries and expectations for the work or services to be provided under an agreement. It typically outlines what tasks, deliverables, or responsibilities are included or excluded, and may reference technical specifications, timelines, or standards that must be met. By clearly delineating what is and is not covered, this clause helps prevent misunderstandings and disputes by ensuring all parties have a shared understanding of the project's extent and limitations.
Scope Requirements. The Contractor shall administer the compliance verification program, provide technical assistance, and perform level 1
View SourceView Similar (2)
Scope Requirements. Based on the information provided by "Genuity" regarding Release 5, the scope of each specific component is as follows: [_] SMW/GRS Reconciliation Development of workplans, estimates, detail designs and some coding efforts [_] Remote Access (Phase 1) Development of workplans, estimates, demo, detail designs, and selection and configuration of COTS products [_] SMW Engineering Enhancements - Release 5 Definition of scope, development of workplans and estimates, high level designs [_] Automated Engineering Packages - Revised Solution Development of workplans, estimates, detail design tasks and some coding efforts
View Source
Scope Requirements. Based on the information provided by Genuity regarding the web-based interface to PSR, the scope of the project is as follows: . This will provide a web-based interface into TBS/PSR for order entry, tracking and status update. PSR is the order entry module of TBS, which is developed by the vendor Metasolv. This will enable field and remote personnel to access limited TBS/PSR functionality remotely. Project will leverage the Genuity effort currently underway to provide web access to the CODA system. A conceptual diagram of the interface is shown in Appendix A. Detailed order status and tracking will not be available until Metasolv can deliver the work management API (currently scheduled for April 2000).
View Source
Scope Requirements. The Contractor shall be capable of providing innovative technologies, as well as traditional methods of site investigation and remediation while complying with all applicable USACE policies and procedures, and applicable federal, state and/or local statutes, rules and regulations. Examples of some of the environmental restoration work that may be required are listed below. These examples are not intended to be all inclusive. a. Conduct a full range of environmental services as required under RCRA, CERCLA, TSCA, CWA, and other federal and state environmental regulations. b. Develop site specific work plans with accompanying sub plans. These sub plans include, but are not limited to, such documents as a UFP-QAPP (Uniform Federal Policy – Quality Assurance Project Plan, a sampling and analysis plan, a site safety and health plan, a Contractor quality control plan, and an erosion control plan. c. Sampling and testing of soil (surface, shallow subsurface, and deep subsurface) and/or other solid matter; sampling and testing of sediment; sampling and testing of groundwater; and sampling and testing of surface water. Soils will be tested for both chemical and geotechnical parameters. Groundwater sampling may involve installation, development, and abandonment of monitoring ▇▇▇▇▇. d. Conduct waste site investigations (e.g., Remedial Investigations, RCRA Facility Investigations, Comprehensive Site Assessments, Site Assessments, etc.) in accordance with Federal, State, and local environmental regulations. This includes preparation of work plans and reports for approval by the Corps of Engineers and the applicable Federal, State, and/or local regulatory authority. e. Prepare remedial action decision documents (e.g., Feasibility Studies, Proposed Plans, Records of Decision, Corrective Measures Studies, Corrective Action Plans, Remedial Action Plans, Remedial Designs, etc.) for approval by the Corps of Engineers and the applicable Federal, State, and/or local regulatory authority. f. Perform risk assessments (both human health and ecological) in support of RCRA, CERCLA, or other state regulated programs. g. Conduct remedial action activities at sites contaminated with the following types of substances: RCRA listed hazardous wastes, RCRA characteristic hazardous wastes, heavy metals, PCBs, asbestos, petroleum hydrocarbons, TSCA regulated substances, radioactive material, and other contaminants not specifically listed. h. Remediation of contaminated soil. Soil remediation ...
View Source
Scope Requirements. Provide a cost estimate to provide the systems solution to the requirements provided by Genuity. . Provide a time period estimate to provide the systems solution to the requirements provided by Genuity.
View Source
Scope Requirements. The scope of BMO covers the most commonly used services required for complete operation and maintenance of federal controlled space and assets. This contract will provide coverage for the five (5) independent geographic zones designated below. Zones will be awarded to offerors by CLIN. Multiple awards may be made in each CLIN. Offerors are to submit a single (1) proposal identifying the zone or zones provided. Offerors must be able to provide coverage to all locations within a proposed zone to qualify for that zone. Z2 Zone 2 Connecticut, Maine, Massachusetts, New Hampshire, Rhode Island, Vermont Z3 Zone 3 Florida, Georgia, North Carolina, South Carolina Z4 Zone 4 Oklahoma, Texas Z5 Zone 5 California, Nevada Z6 Zone 6 Illinois, Iowa, Kansas, Missouri, Nebraska
View Source
Scope Requirements. Based on the information provided by Genuity regarding the TBS RELEASES, the scope of the project is as follows for 4.2.1
View Source
Scope Requirements 
View SourceView Similar (17)

Related to Scope Requirements

  • Time Requirements The Independent Contractor will not be required to follow or establish a regular or daily work schedule, but shall devote during the term of this Agreement the time, energy and skill as necessary to perform the services of this engagement and shall, periodically or at any time upon the request of the Company, submit information as to the amount of time worked and scope of work performed.

  • DBE Requirements A. Notice is hereby given to the CONSULTANT and any SUB-CONSULTANT, and both agree, that failure to carry out the requirements set forth in 49 CFR Sec. 26.13(b) shall constitute a breach of this Contract and, after notification and failure to promptly cure such breach, may result in termination of this Contract or such remedy as INDOT deems appropriate. The referenced section requires the following assurance to be included in all subsequent contracts between the CONSULTANT and any SUB-CONSULTANT: The CONSULTANT, sub recipient or SUB-CONSULTANT shall not discriminate on the basis of race, color, national origin, or sex in the performance of this Contract. The CONSULTANT shall carry out applicable requirements of 49 CFR Part 26 in the award and administration of DOT-assisted contracts. Failure by the CONSULTANT to carry out these requirements is a material breach of this Contract, which may result in the termination of this Contract or such other remedy, as INDOT, as the recipient, deems appropriate. B. The CONSULTANT shall make good faith efforts to achieve the DBE percentage goal that may be included as part of this Contract with the approved DBE SUB-CONSULTANTS identified on its Affirmative Action Certification submitted with its Letter of Interest, or with approved amendments. Any changes to a DBE firm listed in the Affirmative Action Certification must be requested in writing and receive prior approval by the LPA and INDOT’s Economic Opportunity Division Director. After this Contract is completed and if a DBE SUB- CONSULTANT has performed services thereon, the CONSULTANT must complete, and return, a Disadvantaged Business Enterprise Utilization Affidavit (“DBE-3 Form”) to INDOT’s Economic Opportunity Division Director. The DBE-3 Form requires certification by the CONSULTANT AND DBE SUB-CONSULTANT that the committed contract amounts have been paid and received.

  • Interface Requirements 2.4.5.1 The NID shall be equal to or better than all of the requirements for NIDs set forth in the applicable industry standard technical references.

  • Work Requirements The following Partner(s) is/are required to work for the Partnership: (choose one) ☐ - No Partners. No Partners are required to work for the Partnership. ☐ - Specific Partners. The following Partner(s) are required to work for the Partnership: . Compensation, if any, shall be agreed to in a separate document. ☐ - All Partners. All Partners are required to work for the Partnership. Compensation, if any, shall be agreed to in a separate document.

  • Basic Requirements To be eligible for PayPal’s Seller Protection program, all of the following basic requirements must be met, as well as any applicable additional requirements: • The primary address for your PayPal account must be in the United States. • The item must be a physical, tangible good that can be shipped, except for items subject to the Intangible Goods Additional Requirements. Transactions involving items that you deliver in person in connection with payment made in your physical store, may also be eligible for PayPal’s Seller Protection program so long as the buyer paid for the transaction in person by using a PayPal goods and services QR code. • You must ship the item to the shipping address on the Transaction Details page in your PayPal account for the transaction. If you originally ship the item to the recipient’s shipping address on the Transaction Details page but the item is later redirected to a different address, you will not be eligible for PayPal’s Seller Protection program. We therefore recommend not using a shipping service that is arranged by the buyer, so that you will be able to provide valid proof of shipping and delivery. • The shipping requirement does not apply to eligible transactions involving items that you deliver in person; provided, however, that you agree to provide us with alternative evidence of delivery or such additional documentation or information relating to the transaction that we may request. • You must respond to PayPal’s requests for documentation and other information in a timely manner as requested in our email correspondence with you or in our correspondence with you through the Resolution Center. If you do not respond to PayPal’s request for documentation and other information in the time requested, you may not be eligible for PayPal’s Seller Protection program. • If the sale involves pre-ordered or made-to-order goods, you must ship within the timeframe you specified in the listing. Otherwise, it is recommended that you ship all items within 7 days after receipt of payment. • You provide us with valid proof of shipment or delivery. • The payment must be marked “eligible” or “partially eligible” in the case of Unauthorized Transaction claims, or “eligible” in the case of Item Not Received claims, for PayPal’s Seller Protection program on the Transaction Details page. • In the case of an Unauthorized Transaction claim, you must provide valid proof of shipment or proof of delivery that demonstrates that the item was shipped or provided to the buyer no later than two days after PayPal notified you of the dispute or reversal. For example, if PayPal notifies you of an Unauthorized Transaction claim on September 1, the valid proof of shipment must indicate that the item was shipped to the buyer no later than September 3 to be eligible for PayPal’s Seller Protection program. PayPal determines, in its sole discretion, whether your claim is eligible for PayPal’s Seller Protection program. PayPal will make a decision, in its sole discretion, based on the eligibility requirements, any information or documentation provided during the resolution process, or any other information PayPal deems relevant and appropriate under the circumstances. To be eligible for PayPal’s Seller Protection program for a buyer’s Item Not Received claim, you must meet both the basic requirements and the additional requirements listed below: • Where a buyer files a chargeback with the issuer for a card-funded transaction, the payment must be marked “eligible” for PayPal’s Seller Protection on the Transaction Details page. • You must provide proof of delivery as described below.